7/26/2019 01 Fitting Wall Mounted Batten (1 x28W)

1/1

SCHEDULE OF LIGHTING FIXTURES

LF/ 1

Light Fitting Type: - Legend Item No :

1Descriptions : 1x28W Wall Mounted Batten Fluorescent

Fitting

Technical Specification

Technical Characteristics

The luminaire shall be a wall mounted fluorescent bare batten channel light fitting polycarbonate lampholders securely held in UV stabilized, non dis-colouring, high impact end cap assemblies. It shall berobust construction and complying with IEC60598.1; IEC60598.2.1;IEEC60598.2.2; CISPR15; EMC comply to AS/NZS4051. It shall be equipped with 1 x 28W TL5 lampand high frequency electronic ballast. The IP rating is 20 under the Class I electrical insulationcategory.

Luminaire housingThe luminaire housing shall be of sturdy roll-formed construction. The luminaire housing shall be ofelectronic-galvanized steel with epoxy polyester hybrid 0.6mm, injection moulded ABS plastic endcaps. The finishes shall be gloss white powder coated.

Lamps and gearsThe luminaire shall be supplied with 1 x 28W high efficiency TL5 lamp with total output of 2600lumens. The lamp shall have colour temperature of 4000 K and colour rendering index (Ra) of morethan 80. The high frequency (HF) electronic ballast shall be designed to operate 1 x 28W TL5fluorescent lamp.

The electronic ballast should comply with IEC928/929 with production conforming to ISOstandard.

The ballast loss shall not be greater than 3W per ballast with power factor greater than 0.95 whenoperating under rated mains voltage and frequency of 220-240V and 50/60 Hz respectively.

Fitting shall be in HDB approved list.