Light hits a metal plate, ejecting electrons Once ejected, electrons are attracted to a positively...
-
Upload
jordan-long -
Category
Documents
-
view
213 -
download
0
Transcript of Light hits a metal plate, ejecting electrons Once ejected, electrons are attracted to a positively...
THE PHOTOELECTRIC EFFECT
The Photoelectric Effect
Light hits a metal plate, ejecting electrons
Once ejected, electrons are attracted to a positively charged electrode.
Electrode is connected to a sensitive meter.
When light shines on the metal plate, meter deflects (gets a current reading)
When light is turned off, meter reads zero.
Put a negatively charged screen in the way. Ejected electrons will be repelled back down to the metal. No current will be read on the meter.
Low Intensity Light = No Current in Meter
HIGH Intensity Light = Still No Current in Meter
Brighter light does not result in more energetic electrons punching through the screen.
Low Intensity UV Light = Current in Meter!
Electrons make it through the screen
Planck’s Formula
Planck deduced that the energy of a wave of light is tied to its frequency.
E = hfwhere h = 6.6x10-34 J s
UV light = high frequency = high energy. Red light = low frequency = low energy. Red light cannot give the electrons
enough energy to get through the screen, but UV can.
Einstein’s Explanation of the Photoelectric Effect
Light is a wave, but it is sent in packets Each packet has a small quantity of
energy given by its frequency (E = hf) One packet knocks one electron, if it has
the energy Higher intensity does NOT equal more
energetic electrons
Einstein (cont’d)
Low frequency light produces low energy electrons. These electrons cannot push through the negative screen.
Sending more packets of low frequency light will not help. It will just produce more low energy electrons, none of which can get past the screen.
Einstein (cont’d)
High frequency light produces high frequency electrons.
Even a dim beam of high frequency light will get a current reading in the meter.
Increasing the intensity of the beam in this case will mean an increased current reading in the meter.
The Work Function
Applying the law of conservation of energy:Ebefore = Eafter
If we treat this like a perfectly elastic collisionElight = Eelectron
Turns out this is not quite right. It takes some energy to eject the electron from the atom, so the electron ends up with less energy than the light. Every element has a different hold on its electrons. The work done removing the electron is called the work function, W.
Elight = W + Eelectron