ControlArtcontrolart.se/produkter/brochure-controlart-ab-eng.pdf · equipment’s originally...

8
ControlArt The complete corrosion company

Transcript of ControlArtcontrolart.se/produkter/brochure-controlart-ab-eng.pdf · equipment’s originally...

Page 1: ControlArtcontrolart.se/produkter/brochure-controlart-ab-eng.pdf · equipment’s originally developed by the Volvo group since the early ... to have up to 360 pieces of standard

ControlArtThe complete corrosion company

Page 2: ControlArtcontrolart.se/produkter/brochure-controlart-ab-eng.pdf · equipment’s originally developed by the Volvo group since the early ... to have up to 360 pieces of standard

ControlArt ABWe are a company primarily producing corrosion and climate test equipments.

Together with our daughter company, CTD - Corrosion Testing Development AB,

we are also offering consultant work and education in the area of corrosion and corrosion testing. Our major focuses are in the area of modern cyclic corrosion

testing.

ControlArt has been active producing cyclic corrosion test equipments since year 2000 and has been participating actively in the development of the test equipment’s originally developed by the Volvo group since the early 1990.

This means that we have a good knowledge about method development,standardization work and actual corrosion testing in practise.

We can deliver corrosion test equipments that can perform testings that can be verified among our customers to fulfil the demands asked for, by the issuers of

the modern cyclic corrosion test standars.

Our equipments is flexible in their use and customer specific method can easily be implemented.

Page 3: ControlArtcontrolart.se/produkter/brochure-controlart-ab-eng.pdf · equipment’s originally developed by the Volvo group since the early ... to have up to 360 pieces of standard

The EquipmentsThe test conditions concerning temperature, relative humidity,

drying, speed and salt load impact is uniquely even distributed over the test plane. The active test surface is 1*2 m2. This is fairly large for a 2 m3 cabinet. With use of special designed test sample holders from ControlArt it is possible to have up to 360 pieces of standard test panels (100*200 mm) loaded in the

cabinet.

We also provide service calibration and if necessary repair of ourdelivered cabinets either directly or via our agents in Europe and Asia.

Page 4: ControlArtcontrolart.se/produkter/brochure-controlart-ab-eng.pdf · equipment’s originally developed by the Volvo group since the early ... to have up to 360 pieces of standard

ModelsWe provide our standard Test Cabinets in three different models,

TC 210, TC 215 and TC 220.

Common for all are:• Same moulded plastic cabinet and same machinery unit size.• Control system with modern process regulators and PLC technic.• Automatic “rain mixing system” i.e. the salt solutions used. The salt concentration and pH is programmable though the control system.• Salt solution application systems according to Volvo and Volvo/Ford test standards.• Three programmable time contacts (24V relay output).

Page 5: ControlArtcontrolart.se/produkter/brochure-controlart-ab-eng.pdf · equipment’s originally developed by the Volvo group since the early ... to have up to 360 pieces of standard

TC 210 Cabinet• Separate cooling giving a cooling temperature around 0°C.

TC 215 Cabinet• Separate cooling giving a cooling temperature around 0°C.• Salt fog system according to ISO 9227 (NSS).• Scrubber for washing out the salt from the used salt fog air.• Increased aeration to get rid of salt fog after spraying.• Automatic water spraying of the interior of the climatic chamber.• In-line heater in order to control the chamber temperature during the salt fog step.

TC 220 Cabinet• Salt fog system according to ISO 9227 (NSS).• Scrubber for washing out the salt from the used salt fog air.• Increased aeration to get rid of salt fog after spraying.• Automatic water spraying of the interior of the climatic chamber.• In-line heater in order to control the chamber temperature during the salt fog step.• Separate cooling giving a cooling temperature down to -20 °C.• Designed heat exchanger to make it possible to reach cooler than -15°C.

The temperature range of the cabinets can be set to:• TC 210 and TC 215: ca. 10 °C to 65 °C.• TC 220: less than -15 °C to 65 °C.

Humidity range: lower than 30 %RH to 98 %RH controlled relative humidity. The lower limit depends on the dryness of the compressed media air fed to the equipment.

From a fully loaded cabinet the drying up time where a controlled climate control can be started is less than 40 min. The maximum thermal load (iron material) is 200 kg. The active test plane is 1*2 m2.

Page 6: ControlArtcontrolart.se/produkter/brochure-controlart-ab-eng.pdf · equipment’s originally developed by the Volvo group since the early ... to have up to 360 pieces of standard

As the table shows the TC 110 can perform testing for all the Volvo methods as well as the Volvo/Ford method.Number 2, 3 and 5 have the same base test cycle but differentiates in thedemands and verification procedures.* The test standard is equal to Ford CETP 00.00-L_467.** Not recommended for continuous testing.

No. Test method name Standard Test method developed in theequipment

TC 210

TC 215

TC220

Cyclic test method

1 VICT (Volvo Indoor Corrosion Test Method)

STD 1027,1375

Yes Yes Yes Yes Yes

2 Volvo ACT I (Volvo Car)

VCS 1027,149

Yes Yes Yes Yes Yes

3 Volvo ACT I(Volvo Group)

STD 423,0014

Yes Yes Yes Yes Yes

4 Volvo-Ford ACT II

VCS 1027,1449*

Yes Yes Yes Yes Yes

5 Scania Corrosion Test Method

STD 4319 Yes Yes Yes Yes Yes

6 ISO Cyclic Cor-rosin Test Method

SS-EN ISO 16701:2008

Yes Yes Yes Yes Yes

7 French Corrosion Test Method VIC 2

VIC 2 Yes Yes Yes Yes Yes

8 Renault Corrosion Test Method ECC1

D17 2028 / B No No Yes Yes Yes

9 Cyclic VDA Cor-rosion Test Method

VDA 233-102 No No No Yes Yes

10 VDA Corrosion Test Method

VDA 621-415 No No No No No

11 Neutral Salt Spray NSS

ISO 9227 No No Yes** Yes** No

12 Daimler Chrysler KWT-DC

KWT-DC No No No Yes Yes

13 Peugeot PSA TCAC

D13 5486 No Yes Yes Yes Yes

Test Methods

Page 7: ControlArtcontrolart.se/produkter/brochure-controlart-ab-eng.pdf · equipment’s originally developed by the Volvo group since the early ... to have up to 360 pieces of standard

The units can be placed in different directions. The door can and should not be blocked. The machinery unit needs to be placed on the right side of the test

cabinet.

The Cooler/Freezer can be placed according to customer needs and is determined during ordering. The space of the unit is 0,8*0,6 m, height is

approx. 1,9 m.

The maximum height of the equipment is 2,35 m when the door of the test Cabinet is open.

SoftwareThe equipment comes with a control system pre-programmed with the must

used test standards and there is space to add more customer specific test procedures.

In addition to this with a usual PC (Windows) a logger program is included. From this program it is possible to export Excel-files of historical data.

An optional product can, with help of a GSM modem, and an Alarm Monitor software, report media disturbances or other running errors via SMS and/or

mail.

Space Demands

Page 8: ControlArtcontrolart.se/produkter/brochure-controlart-ab-eng.pdf · equipment’s originally developed by the Volvo group since the early ... to have up to 360 pieces of standard

ControlArt ABTärnvägen 13 BSE-475 40 Hönö

SWEDEN

[email protected]

Tel. +46 (0) 703 78 52 12