MODEL GE2 DUAL GAS & ELECTRIC WATER HEATEROWNER’S MANUAL

HANSEN

Dimensions Height 315mm Width 305mm Length 565mm Model GE2 Capacity 19,5 Litres Dry Weight 9kg

Water Max Water Pump Supply Pressure 1,8 kPa Fiamma Aqua 8 Recommended Working pressure 2 kPa Pressure Relief Valve Setting 3,0 kPa

Gas Type LPG Operating gas pressure 2,8kPa Manifold pressure 2,1kPa Heat input 1000watt Injector size 0,70mm Gas consumption 120 g/h Recovery 25L/Hr

Electricity

Gas/electronics 12v DC (Min - 10v Max 13,8v) Immersion element 1000watt Voltage 230v~50hz Working pressure 200kPa Moisture res istance IPX1

120

Plastic dust Travel cover

WARNING : Supply pump pressure MUSTNOT exceed 1.5 Bar. Recommend pumpFiamma Aqua 8

9

10

1) Heat exchanger body2) Thermostat mounting 3) Exhaust Flue4) Wind shield5) Gas burner6) Gas connection7) Sealing grommet8) Gas Solenoid valve9) Gas Injector10) Spark Electrodes

Checking the spark & flame sense

1) Remove the upper heat plate by loosening the securing 7mm nut.2) Inspect the ceramic electrodes for cracks3) The distance between the spark electrodes must be between 4-5mm.4) The distance from the sense electrode and the burner must be 4-5mm.

Black

Spark Igniter

Electronic Control Board 910

+-

Manufactured by : Hansen Water Heaters Pty Ltd www.hansenproducts.co.za

Exterior Travel Cover

Fitt ing the Exterior cover by pushing it over the flue exhaust.Ensure the Cover is vertically straightand line up the locking clip to the the first slot on the flue vent (Pic 1)

Pic 1

PUSH

2 PULL

To remove the cover push the locking clip in the side furthest from the face.Remove by pulling on the tabs, the cover fits snugly use a flat object against the tab to pry off if tight.

1 PUSH