Transcript of 3 LDC borstplätering LDC Portable Electroplating 1.Cold process: Used at room temperature, no...
- Slide 1
- Slide 2
- www.ldc-brushplating.com2
- Slide 3
- 3 LDC borstpltering LDC Portable Electroplating 1.Cold process:
Used at room temperature, no stress or adjustments because of
termal distorsion. 2.To tolerance: Normaly no machining required
3.Quick metal build-up: 0,05 mm in 10-15 min. 4.Plating: On all
conductive materials, cast iron, stainless, mild steel, copper,
chrome etc 5.Dense deposits: No or very little porosity in most
coatings 6.Many differens metals: Nickel, Gold, Silver, Copper,
Cobolt, Zinc and Alloys. 7.Excellent bonding: Molecular bonding
results in very god adhesion, all coatings can be machined,
grinding or polished. 8.Mobile equipment: The repair can be done on
site
- Slide 4
- www.ldc-brushplating.com4 LDC borstpltering External bearing
surface that had been damaged. Plate up the damage with LDC-2904
copper hi-speed that has a hardness of 250 brinell.
- Slide 5
- www.ldc-brushplating.com5 LDC borstpltering Now the bearing
surface are plated with copper. Even grinded-in to the correct
dimensions and ready to plate a top coating wish is a nickel with a
hardness of 400 brinell and also gives a excellent protection from
new damages.
- Slide 6
- LDC borstpltering www.ldc-brushplating.com6 A shaft with two
damaged / worn bearing surfaces.
- Slide 7
- www.ldc-brushplating.com7 LDC borstpltering Now the shaft is
masked and ready to start with the plating of the LDC-2904 copper
Hi- speed that has a hardness of 250 Brinell.
- Slide 8
- www.ldc-brushplating.com8 LDC borstpltering Now is the copper
grinded into the minimum tolerance and then plated up to the
correct tolerance with a hard nickel which is 54 HRC.
- Slide 9
- www.ldc-brushplating.com9 LDC borstpltering Now is the Nickel
plating in progress.
- Slide 10
- www.ldc-brushplating.com10 LDC borstpltering Now the bearing
surfaces is restored to its original tolerance with at top layer of
Nickel.
- Slide 11
- www.ldc-brushplating.com11 LDC borstpltering Shaft with two
sealing surfaces that have been damaged by the seals.
- Slide 12
- www.ldc-brushplating.com12 LDC borstpltering We Plate up the
damage with the LDC-2904 Copper Hi-speed that is 250 Brinell.
- Slide 13
- www.ldc-brushplating.com13 LDC borstpltering Now the shaft is
machined to the right measurement and ready to plate the top
layer.
- Slide 14
- www.ldc-brushplating.com 15 LDC borstpltering Tel: +46 248
17440 info@ldcab.se Now the plating of a hard and dense top layer
of LDC 2874 nickel tungsten.
- Slide 15
- www.ldc-brushplating.com 16 LDC borstpltering Tel: +46 248
17440 ldc@swipnet.se Now the shaft is finnisht to its original
dimension with a hard and dense top layer of LDC 2874 nickel
tungsten.