Post on 03-Nov-2014
description
WT4603 Wood Processing Safety & PracticeAutumn Semester 2011Lecture Unit 8 (Week 12)
Final Lecture: WT4603 Exam Preparation Notes Prepared by: Mr. Joseph Lyster Date: 21-11-2011
Exam Format:
Department of Design and Manufacturing Technology
WT4603
Department of Design and Manufacturing Technology
WT4603
Exam Tips
Question Tips
Section A: Long Questions (Answer 2 Questions) (* = Compulsory)
1 (Teachers)*-Promoting Safety-Legislation-Risk Magnitude/Assessment
2 (Wood Science)*-Duties of Employer/ Employee(s)-Legislation-Risk Magnitude/Assessment
3 -Rip Saws/ Surface Planers-Calculations
4 -Wood Processing Procedures/Practices
Section B: Short Questions (Answer Any 10 Questions)
1-15
-Machines: Thicknesser, Router (Router Bits), Rip Saw, and Surface Planer-Processing-Start/Stop Mechanisms-Legislation -Wood Dust-Mechanical Hazards
WT4603
Exam Techniques:
• Question Types• Marking Scheme• Response types – Bullet points• Notes• Sketches + Annotations• Colour• Rough work
2009/10 Paper
Department of Design and Manufacturing Technology
WT4603
Department of Design and Manufacturing Technology
Department of Design and Manufacturing Technology
WT4603
2010/11 Paper
Department of Design and Manufacturing Technology
WT4603
DISCUSSIONTopics:
- Lectures- Labs- Assignments- Project Work- General Feedback
Department of Design and Manufacturing Technology
WT4603