Quick Start

1. Plug in power and turn the switch from “OFF” to “ON” on panel.2. Add remote control:

a. Press “SET” + “#” + “SET” + “00”, alarm panel displays “00”.b. Press any button of remote control, panel sounds “bi-bi”.c. Press any button of 2nd remote control, panel sounds “bi-bi”. Repeat this step for other

remote control or press “SET” to end.3. Add detector/sensor:

a. Switch off all sensors.b. Group each magnectic detector and magnetic bar together like diagram below, do all for

magnectic detector and magnetic bar.

c. Press “SET” + “#” + “SET” + “01”. d. Separate magnectic detector and magnetic bar to trigger alert, panel sounds “bi-bi”.

Separate another set magnectic detector and magnetic bar, repeat this step for the rest of magnectic detector and magnetic bar and press “SET” to end.

e. Press “SET” + “#” + “SET” + “01”. f. Switch on smoke sensor or motion sensor, panel sounds “bi-bi”. Repeat this step for

the rest of smoke sensor or motion sensor one by one, press “SET” to end.

4. Add phone number to call when alarm triggered:a. Connect the phone line as shown below.

b. Press “SAVE” + “1-9” + “*” + “phone number” + “SAVE”. “1 – 9” is the sequence of phone number to call when alarm triggered, “1” for the first phone number, “2” for second phone number. Example of “phone number” is “0121234567”.

c. Repeat step B for the rest of phone number.