Post on 29-Jun-2015
TASK 3 – P4,P5,M2
STEP 1: First of all, before you perform any
installation, make sure that you have disconnected the power supply.
STEP 2: We then had to take the wireless NIC card
out of the anti – static bag to get ready to install it into the computer.
STEP 3: Then you will need to slot your card into the
motherboard slot, make sure you have placed it into the correct slot and don’t try to force it into the wrong slot.
STEP 4: Then you will need to lock the card into
place by pushing the locking arm down until you have heard it click into place.
STEP 5: Once it has then been installed, you will
be able to then screw the antenna onto the card.
STEP 6: Once you have done this, you are
finished installing the wireless NIC card.
STEP 1: First of all, you will need to choose the
correct model and type of your wireless NIC card.
STEP 2: Once you have chosen your card, you
will then need to click on ‘Auto Run’ to start the installation.
STEP 3: You will then want to click on the
‘Repair’ option and then click next.
STEP 4: Once you have done that, it will start to
install the driver for your wireless NIC card.
STEP 5: You will then need to choose what
network you want your card to connect to. If your network doesn’t appear, try pressing the ‘Refresh’ button.
STEP 6: You will then start to connect to your
chosen network.
STEP 7: Once you have done that, you have
finished. The following picture is an example of what it will look like when your wireless NIC card has connected to your chosen network.