Transcript of Unit 5D Turning Points in Physics Chapter 1 – The electron.
- Slide 1
- Unit 5D Turning Points in Physics Chapter 1 The electron
- Slide 2
- Part 1 The discovery of the electron Allesandro Volta invented
the first battery in 1800, but the nature of electricity wasnt
really understood It was found that, by making and breaking a
circuit and using coil of wire, high voltages could be generated,
producing sparks (1850s) But could electricity flow even without
air?
- Slide 3
- Gas Discharge Tubes Developments in glass blowing and vacuum
pump technology were key to making progress Around 1857 Heinrich
Geissler produced the first working gas discharge tube
- Slide 4
- Gas Discharge Tubes It was found that, for low pressure gas,
electricity was conducted and glowing regions appeared in the tube.
This was attributed to rays coming from the electrodes, but there
was much debate about their source and nature. Different gases in
the tube produced different colours of light.
- Slide 5
- Gas Discharge Tubes
- Slide 6
- Soon decorative Geissler tubes were being sold as amusements,
like todays plasma balls.
- Slide 7
- Gas Discharge Tubes The details of the glowing regions also
depended on the applied voltage and the pressure of the gas
- Slide 8
- FF: What causes the glow? Near the cathode: The strong electric
field ionizes some gas atoms. Nearby positive ions hit the cathode
and release more of the free electrons Electron-ion pairs
recombining release energy as emitted photons (negative glow) Near
the anode: Some electrons get further and collide with atoms to
excite them, then the atoms emit photons when they drop back to
their ground states.
- Slide 9
- Crookes Tube At lower gas pressures the glass itself glowed
Moving the anode around the corner suggested the cathode was the
source of the rays Casting of shadows suggested rays travelled in
straight lines (Roentgen went on to discover x-rays using the same
apparatus)
- Slide 10
- A flurry of activity... William Crookes, Johann Hittorf,
Juliusz Plcker, Eugen Goldstein, Heinrich Hertz, Philipp Lenard,
J.J. Thomson and others investigated the nature of cathode rays
William CrookesJ. J. ThomsonEugen Goldstein
- Slide 11
- Key Experimental Findings A paddle wheel is pushed from to +
when a voltage is applied. Shining light on it doesnt move it. The
rays are deflected by magnetic and electric fields.
- Slide 12
- Pulling it all together J.J. Thomson ended the debate in 1897.
He demonstrated that cathode rays: 1.have energy, momentum and
mass, 2.are not electromagnetic waves, 3.have a negative charge,
4.have the same properties even if you change the gas or the
material of the cathode, 5.have a specific charge much higher than
that of hydrogen atoms, 6.travel in straight lines. The electron
was discovered.
- Slide 13
- Thermionic Emission In discharge tubes electrons are produced
by ionising gas atoms with an electric field A more efficient way
of producing them is to use thermionic emission and accelerate them
with an electric field in a vacuum. Used in Valves (Fleming, 1904)
and enabled the birth of electronics and computers Still used in
some esoteric applications (eg iTube amplifier and dock)
- Slide 14
- Thermionic Emission Increasing temperature increases the
electron energy So at higher temperature more electrons have enough
energy to leave the surface of the metal Like a crowded fish pond!
With some encouragement, electrons can leave permanently
- Slide 15
- The Electron Gun
- Slide 16
- Slide 17
- Electrons are released through thermionic emission are
accelerated towards the anode Some escape through a hole in the
anode No field beyond the anode, so travel on with constant
velocity Need a vacuum to avoid electrons colliding with other
particles Filament current adjusts number of electrons (intensity
of beam) Accelerating voltage adjusts speed of electrons (energy of
beam) (usually inside of tube has a conductive coating to provide a
return path and keep the tube itself neutral)
- Slide 18
- Speed of Electrons...provided we are well away from the speed
of light!
- Slide 19
- Electron Deflection E field The faster the electrons are
travelling, the less they are deflected
- Slide 20
- Electron Deflection E field Constant vertical acceleration and
x velocity, so path here is PARABOLIC (remember SUVAT) Constant
vertical force of eV/d experienced by electrons between plates p p
p p So maximum deflection Y is proprtional to V p Y
- Slide 21
- Electron Deflection B field Helmholtz coils give a (calculable)
uniform field over most of the volume in between the coils If we
provide a magnetic field perpendicular to the e-beam we induce a
circular path
- Slide 22
- Electron Deflection B field Magnetic field produces a force
always perpendicular to direction of electron travel Circular
motion Fine beam tube contains a horizontally mounted e- gun and is
filled with low pressure gas to show electron path The faster the
electrons are travelling, the less they are deflected
- Slide 23
- Specific Charge of the Electron (1) Balance opposite forces
from E and B fields If e-beam is undeflected: This gives us the
velocity. Now switch off B-field to get deflection y: All directly
measurable quantities
- Slide 24
- Specific Charge of the Electron (1) Alternatively: we still
have Now switch off E-field to get circular motion, measure radius
r: All directly measurable quantities You dont need to memorise
this, but you do need to know which equations apply (on formula
sheet) and be able to do similar calculations
- Slide 25
- Specific Charge of the Electron (2) Deflect with a B field,
calculate centripetal force (fine beam tube) All directly
measurable quantities
- Slide 26
- Specific Charge of the Electron (2) For a better value can
measure values of r and B. Plotting r against 1/B gives a straight
line with gradient k e/m is then calculated: Again, you dont need
to memorise this, but should be prepared to answer questions on the
experiment
- Slide 27
- Significance of e/m e/m=1.76x10 11 Ckg -1 This was 1860 times
larger than the Hydrogen ion, the largest known value so far. But
is the charge much bigger, the mass much smaller, or a bit of both?
In 1895 Thomson could not draw any further conclusions, as neither
e or m were known independently.
- Slide 28
- Millikans Oil Drop Experiment Very difficult to do! But allowed
him to determine the charge on the electron in 1913. Robert
Millikan
- Slide 29
- Millikans Oil Drop Experiment Drops of oil fall through the
hole in the top plate By measuring the size of the drop and the
speed at which it falls you can calculate its mass Some become
ionised by the radiation source By adjusting the pd between the two
plates weight and electrostatic force can be equalised: the drop is
stationary You can then calculate the charge on the drop
- Slide 30
- Millikans Oil Drop Experiment For a stationary drop: So if we
know m we can calculate Q Note that the top plate must have the
opposite charge to the oil drop
- Slide 31
- Finding the mass of an oil drop With no electric field, the oil
drops fall at their terminal speed. Millikan could measure the
speed of the drop with his microscope Stokes Law gives the drag
force: 6 rv At terminal velocity: We can measure the density of the
oil and write: Now we know r we can turn on the field and write The
only unknown is Q... is viscosity of air
- Slide 32
- Millikans Results After making many measurements on many
charged oil droplets, he found that the charge Q was always an
integer multiple of 1.6 10 19 C. In other words, he showed that
electric charge is quantised in whole number multiples of 1.6 10 19
C. He concluded that the charge of the electron is 1.6 10 19 C the
whole number n corresponds to how many electrons on the droplet are
responsible for its charge. The mass of the electron was very
small, so there must be other things in the atom providing the mass
He was within 2% of the currently accepted value What might have
been the sources of experimental error he had to deal with?
- Slide 33
- Something to note You might be asked about the motion of drops
with the field on, be careful: Tiny oil drops reach terminal
velocity (up and down forces equal) in a fraction of a second They
then move at constant velocity The velocity depends on the drag
force, weight and electric force: =0 d) Electric force equal to
weight, drop is stationary, so no drag force
- Slide 34
- Checklist What are cathode rays and how were they discovered?
Why does the gas in a discharge tube emit light of a certain
colour? How is a beam of electrons produced in a vacuum tube? How
can electron beams be controlled and deflected? What happens to the
deflection of an electron beam if the speed of the electrons is
increased? How can we determine the speed of the electrons in a
beam? How can e/m be measured? What measurements are needed to
determine e/m? What was the significance of the first accurate
determination of e/m? How can e be measured? What measurements are
needed to determine e? Why was Millikans determination of e
important?
- Slide 35
- Do all the Chapter 1 summary questions! Lets look at some exam
questions www.Exampro.co.uk www.Exampro.co.uk