Ultrafiltrate system for Bottles - 3D printing system for Bottles (250, 500 and 1000 ml) This is an...

Post on 25-Apr-2018

214 views 1 download

Transcript of Ultrafiltrate system for Bottles - 3D printing system for Bottles (250, 500 and 1000 ml) This is an...

UltrafiltratesystemforBottles(250,500and1000ml)Thisisanultrafiltratesystemforusewith250,500and1000mlbottlesandMilliporefilterof0.45umand50mmdiameter.Thissystemcanbesterilizedwithgas,alcoholorultravioletlight.Theideaistokeeptheliquidsterileallthetimeandnothavetopassitfromasterilecontainertothebottle.Thedesignismadetobeeasilyprintedandassembledusingonlyepoxyglue.AnotherextramaterialisanO-ringof45mmindiameter.Instructionsforassemblyanduseareinthe"Instructions.pdf"file.3Dprint: I used these parameters.Plastic acrylonitrile butadiene styrene (ABS) of 1.75 mm diameter. Fill density 90%, thick shells, layer height 0.2, slow print speed.Assembly:

1 Placetheringinthetube.

2 Gluethecupwithepoxyglueasindicatedbythearrow(thethreeelementsform

thebody1).PlacetheO-Ring.

3 GluethestrainerontotheCap(thetwoelementsformthebody2).

ModeofUse:

1 Screwbody2ontotheCostartube.

2 Insertthefilterpaper.

3 Screwbody1tobody2.