The Electronics Kit

TEE2O1

Mr. Payne’s Period 5

Room S111

Contents of the Kit

This is the Kit !

Each group will be responsible for maintaining the contents of 1 kit.

The Electronics Kit

Identify the Parts in Each Bag

You should be able to identify the contents of each bag. Make sure each bag is kept separate from other bags.

Note the unbagged:Parallel Port Wire 1mWire strippers/cutters 1Pliers 1

Wire - 5 colours hookup wire 25'

Bag One

Resistors, LEDs, Transistors and Capacitors

110 ohm resistors 2220 ohm resistors 161K ohm resistors 42K ohm resistors 1

LEDs (red) 16LEDs (green) 2LEDs (yellow) 2

1N4001 (transistor) 6

2.2uF capacitor 1

Bag Two

Motors and 25 pin parallel port connector kit.

PN2222A 4PN2907 41V-12V DC motor 1stepper motor 1

DB25 Plastic Hood 1DB25 D-sub connector - crimping style 1

Bag Three

More Resistors

10K ohm resistor 851K ohm resistor 1100K ohm resistor 1510K ohm resistor 11.5M ohm resistor 1

Bag Four

Wire for 25 pin connector

Male crimp pins 16

Wire - 5 colours hookup wire 25 inches

Parallel Port Wire 1m

Bag Five

Buttons and Integrated Circuits

74LS194 - 4-bit Bi-directional shift register 1

74LS154 - 4 to 16 de-Multiplexer 1

Push button 8

Bag Six

8 Segment Display and Integrated Circuits

74LS245 - Transciever 174LS259 - 8 bit addressable latch 2555 - Timer 1

Bag Six

More Integrated Circuits

74LS00 - NAND 174LS02 - NOR 174LS04 - Inverter 174LS08 - AND 174LS32 - OR 174LS47 - 7- Segment decoder/driver 174LS74 - Dual D flip-flop 1 74LS86 - XOR 1

The Big Cahuna The Power Board and Switches

and Input / Output Lights

The electronic experimenter box is where you provide power and ground to your circuits.

How It Works

See the upcoming Powerpoints on Labs 4.2.1 and 4.2.2

How It Works

Next Steps

Be sure that you know where all parts belong before you use them to make circuits.

Remember to replenish your kit for the next class!

A full parts list for the kit is available at http://www.classictechnology.ca/