Setting Probe and Cutting Tool

Step 1: Mark an object with a 90 Degree angle with a pen as a reference point. In this

example we used a steel brick. This is for the X axis.

Step 2: Using the probe, make contact with the reference point. This is for the X axis.

Step 3: Hover over the X axis.

Step 4: Press "Probe touch point" to set your probe touch point.

Step 5: Update your probe touch point.

IMPORTANT: After updating a point, whether it is the probe or cutter touch point, the

change will be seen in the following areas.

Step 6: Mark the rim with a pen to use as a reference point to find the Z axis.

Step 7: Use the probe to touch the marked reference point. This is for the Z axis.

Step 8: Hover over the Z axis.

Step 9: Press "Probe touch point" to set your probe touch point.

Step 10: Update probe touch point.

Step 11: Rotate 4 point post so that you are now using the cutting tool.

Step 12: Use the cutting tool to touch the marked reference point. This is for the X

axis.

Step 13: Hover over the X axis.

Step 14: Press "Cutter touch point" to set your probe touch point.

Step15: Update your cutter touch point.

Step 16: Use the cutter to touch the marked reference point. This is for the Z axis.

Step 17: Hover over the Z axis.

Step 18: Press "Cutter touch point" to set your probe touch point.

Step 19: Update your cutter touch point.