Post on 09-Jan-2016
description
A tool for communication
To exchange scientific knowledge
Journal of American Chemical Society Chemical Communications Journal of Cell Biology Genetics American Journal of Physics
Science Research Paper Format
Title should reflect your research area Examples of inappropriate titles
- A magical fertilizer - Save the world with vegetables
Examples of good titles - Investigations on the breakdown of Aspartame- Effects of refrigeration and room temperature on proliferation of yeast on honey
Present tense for discussing general facts or concepts, and past tense for methods and specific results observed in the experiment
Short summary of the project (< 300 words)
State the objectives of the project
Briefly describe the materials and procedures used in your project
Give a summary of your findings; discuss implications of findings
Evaluating different methods of synthesising biodieselBiodiesel technology is actually gaining popularity nowadays. Many
are interested in lowering the consumption of fossil fuel. Unlike fossil fuels, biodiesel produce fewer pollutants such as CO, SO2 and unburnt hydrocarbon. In the past, production of biodiesel engages the agricultural industries such as producing corn ethanol to develop crops for manufacturing biodiesel. However, it is energy- intensive [4], not renewable, not economical and its production contributes to pollution and global warming [5]. Lastly, it occupies cropland suitable for food production. However, what is special in the current biodiesel technology is that waste cooking oil (WVO) obtained from coffee shops is used as starting material to synthesize biodiesel. In this paper, the method of using acid- catalysed, base- catalysed and acid- base catalyzed transesterification to synthesise biodiesel is shown and the qualities of the biodiesel are compared. The best synthesized biodiesel will be eventually compared to commercially produced biodiesels to determine which one fares better.
Three types of transesterification processes (acid-catalysed, base-catalysed, acid-base catalysed) were compared and evaluated in terms of yield, total and bound glycerol content, density, viscosity, heat of combustion and combustion rate. The base-catalysed transesterification was carried out with methanol and sodium hydroxide as a catalyst while the acid-catalysed transesterification was carried out with methanol and 98% w/w concentrated sulfuric acid as a catalyst. The acid-base catalysed transesterification was carried out by acid pretreatment followed by base catalysed transesterification. For all processes, reflux was carried out at 65°C for a total of one and a half hours. Results showed that the conversion of waste vegetable oil to biodiesel was the highest through acid-base catalysed transesterification, followed by base-catalysed transesterification and acid-catalysed transesterification. Correspondingly, the quality of biodiesel synthesised from acid-base catalysed transesterification was also generally the best.
Call attention to the specific subject, define the problem or question that you are trying to answer with your investigation
Provide background information and present the results of other studies (literature review)
Fatty acid methyl esters originating from vegetable oils and animal fats are known as biodiesel. Biodiesel fuel has received considerable attention in recent years, as it is a biodegradable, renewable and non-toxic fuel. It contributes no net carbon dioxide or sulfur to the atmosphere and emits less gaseous pollutants than normal diesel (Lang et al., 2001; Antolin et al., 2002; Vicenteet al., 2004). There are four primary ways to make biodiesel, direct use and blending, microemulsions, thermal cracking (pyrolysis) and transesterification (Ma andHanna, 1999). The most common way is transesterificationas the biodiesel from transesterification can be used directly or as blends with diesel fuel in diesel engine (Peterson et al., 1991; Zhang et al., 2003).
Biodiesel from heterotrophic microaglae oilMiao, X., Wu, Q (2005). Biodiesel from heterotrophic microalgae oil. Bioresour.Technol. 97, 841–846.
Fatty acid methyl esters originating from vegetable oils and animal fats are known as biodiesel.
Introduction (Example)Introduction (Example)
Biodiesel from heterotrophic microaglae oilMiao, X., Wu, Q (2005). Biodiesel from heterotrophic microalgae oil. Bioresour.Technol. 97, 841–846.
Definition of biodiesel
Biodiesel fuel has received considerable attention in recent years, as it is a biodegradable, renewable and non-toxic fuel. It contributes no net carbon dioxide or sulfur to the atmosphere and emits less gaseous pollutants than normal diesel (Lang et al., 2001; Antolin et al., 2002; Vicenteet al., 2004). Advantages of biodiesel
There are four primary ways to make biodiesel, direct use and blending, microemulsions, thermal cracking (pyrolysis) and transesterification (Ma and Hanna, 1999). The most common way is transesterification as the biodiesel from transesterification can be used directly or as blends with diesel fuel in diesel engine (Peterson et al., 1991; Zhang et al., 2003).
Methods of synthesising biodiesel
Complete information of materials and methods used ,conditions present, actions, experimental design, etc.
Usually has sub-headings and matches those to be used in Results
Sufficient information must be given so that the experiments could be reproduced
2.1. Materials
Chitin (MW ¨ 310 kDa, degree of deacetylation 10%) prepared from crab shells was donated by Kitto Life Co. (Seoul, Korea). For the preparation of chitin derivative, 2-chloroethylamino hydrochloride purchased from Sigma Chemical Co. (St. Louis, MO). The microorganisms tested for antibacterial activity were obtained from KCTC (Korean Collection of Type Cultures). Onitrophenyl-h-d-galactoside (ONPG), 1-N-phenyl-naphthylamine (NPN) was obtained from Sigma Chemical Co. (St. Louis, MO). All other reagents were of the highest grade available commercially.
Antimicrobial action of novel chitin derivativeJe, J-Y., Kim, S-K (2005). 97, 841–846. Biochimica et Biophysica Acta 1760 , 104 – 109
Materials and Methods Materials and Methods (Example)(Example)Antimicrobial action of novel chitin derivative
Je, J-Y., Kim, S-K (2005). 97, 841–846. Biochimica et Biophysica Acta 1760 , 104 – 109
2.2. Synthesis of water-soluble chitin derivative
Chitin derivative was synthesized as shown in Scheme 1. Chitin was aminoalkylated using the method of Clifford and Naoyuki [13]. Aqueous 3.0 M (15 ml) 2-chlorethylamino hydrochloride was added to chitin (0.30 g) with stirring at 65 C. NaOH of 3.0 M (15 ml) was added to the reaction mixture dropwise, and continuously stirred for 18 h. After reaction, solid state chitin was removed using filter paper. Subsequently, the reaction mixture was acidified with 0.1MHCl, 0.0001MHCl, and dialyzed against water for 2 day. The product was freeze dried to give the amino-derivatized chitin (AE-chitin: 0.403 g).
Display data with logical development showing how your findings satisfy your objectives
Use tables and figures
Fig. 4. Release of 260 nm absorbing material from S. aureus suspensionstreated with 73.5 Ag/ml ( –.– ) and 147 Ag/ml (–o–) of AEC.
Antimicrobial action of novel chitin derivativeJe, J-Y., Kim, S-K (2005). 97, 841–846. Biochimica et Biophysica Acta 1760 , 104 – 109
Summarise your Results
Interpret and explain (where possible) the data and results of the experiment
Compare your findings to those of other studies – list similarities or differences observed
Discussion (Example)Discussion (Example)Antimicrobial action of novel chitin derivativeJe, J-Y., Kim, S-K (2005). 97, 841–846. Biochimica et Biophysica Acta 1760 , 104 – 109
As shown in Table 2, AEC markedly inhibited the growth of most Gram-negative bacteria, E. coli, S. typhimurium and P. aeruginosa. MIC values of AEC were 62.5 Ag/ml against E.coli and S. typhimurium, respectively. In the case of P. aeruginosa, AEC was more effective than other Gram-negative bacteria, MIC value was 7.813 g/ml. AEC also effectivelyinhibited the growth of Gram-positive bacteria, MIC values were 125 g/ml, 62.5 g/ml and 62.5 g/ml against S. aureus, L. monocytogenes, and E. faecalis, respectively.
Draw conclusions from results obtained
Summarize your evidence for each conclusion
Relate to objectives of research
Suggest future work
For better credibility, you have to review the literature and show that your contribution extends from a solid foundation of research
List only the references cited in your research paper.
At least 5 references are cited from various sources (at least 3 scholarly refs.)
Use citation builder (convenient to use) :http://www.lib.ncsu.edu/lobo2/citationbuilder/index.php
Thank people who helped you with your project
Length of report ( 3000 words)
Typed written, double spacing, Times New Roman font of size 12 or Arial Font of size 11
Proper citation (APA format)
Introduction
There are four primary ways to make biodiesel, direct use and blending, microemulsions, thermal cracking (pyrolysis) and transesterification (Ma and Hanna, 1999).
In-text Citation (Example)In-text Citation (Example)
References
Ma, F., Hanna, M.A., (1999). Biodiesel production: a review. Bioresour.Technol. 70, 1–15.
Guidelines on writing a science research paper
Guidelines on writing a science research paper for innovation project
Assessment rubric for science research paper
Assessment rubric for science research paper for innovation project
Assessment rubric for math research paper
Assessment rubric for web report
Deadline for research paper: Term 3 – after Semi Judging (report results up to semi-finals)
SRC application forms