Post on 28-Jan-2019
ROMIGL 350MToolholder Program
Straight clamping unitStandardC4-TRE-BT65A
(343-830111C997-RC)C4
StandardC4-TLE-BT65A(343-830111C997-LC)
C4
Straight clamping unit (special offer!)For quotation343-830111C564C4
Straight clamping unitStandardC5-TRE-BT65A
(343-830111C566-RC)C5
StandardC5-TLE-BT65A(343-830111C566-LC)
C5
Right angle clamping unit, shortFor quotation343-830111C569C4For quotation343-830111C570C5
Cut-off holder, adjustableStandardAPB-TNE-BT65A-25SH 32
Straight drill/milling unitStandardEC1:1C4-DNE-BT65A-E
(410104009-65)C4
StandardIC 80bar
1:1C4-DNE-BT65A-I(410104010-65)
C4
Straight drill/milling unit (special offer!)For quotationEC1:1343-830820N1762
(410104005-65)C4
For quotationIC 30bar
1:1343-830820N1763(410104006-65)
C4
19.02.14Subject to change without notice
GL 350MCoromant Capto® - Standard Program
Right angle drill/milling unit, L2=72For quotationEC1:1343-830820N2398
(410504036-65)C4
For quotationIC 80bar
1:1343-830820N2399(410504037-65)
C4
19.02.14Subject to change without notice
GL 350MCoromant Capto® - Standard Program