Post on 31-Dec-2016
11/2013 Page 1 of 2
Flow measurement
QuestionnairePrimary flow elements
Customer data
CompanyName
DepartmentAddress
DatePhoneMobile
FaxE-mail
Purchase order or projectTag no.
Application
Medium
Single-phase Multi-phase
Liquid
Gas
Steam
Gas/liquid ratio (in %): Volume Mass
Density (at operating conditions): kg/m³ lb/ft³Viscosity: cP cST
MW: Cp/cv: Relative humidity:Compressibility factor: Viscosity: cP cST
Superheated Saturated, dry Saturated, wet (water content 0 ... 5 %) %
Minimum Normal Maximum Full scale UnitsFlow ratePressure barg psig mmH2OgTemperature °C °F
Nominal size Schedule Nominal pressure rating MaterialSealing face: Raised face (RF) Flat face (FF) Ring-type joint (RTJ)
Differential pressure at full scale bar psi mmH2O
Commercial information
Medium characteristics
Process data
Pipeline and piping class
Design data
Competitors for this project
Target price € $
WIKA Alexander Wiegand SE & Co. KGAlexander-Wiegand-Straße 3063911 Klingenberg/GermanyTel. +49 9372 132-0Fax +49 9372 132-406info@wika.dewww.wika.de
Page 2 of 211/2013
Pressure taps: Flange taps Corner taps Radius taps Amount:
Tappings: ½" NPT ½" SW Other:Material of nuts and studs:
Pressure taps: Corner taps Flange tapsTappings: ½" NPT ½" SW Other:Material: Stainless steel 316/316L Other:End connection: Butt welded Flanged 1)
Design: ISA 1932 Long radiusTappings: ½" NPT ½" SW Other:
Number of pressure taps:
Material: Stainless steel 316/316L Other:Mounting option, ISA 1932: With flanges Without flangesMounting option, Long radius: Butt welded Flanged 1)
Design: From bar Welded sheetMaterial: Stainless steel 316/316L Carbon steel Other:
Exit cone: 7° 15° Other: Truncated
Tappings: ½" NPT ½" SW Other:
Flanged Dimensions:
Number of pressure taps:End connection: Butt welded Flanged 1)
Mounting types: Compression fitting Flanged version Extractable versionVariants (series): 73 75 78
End support: No Yes
Design: Square edge Quarter circle Eccentric Conical entranceMaterial: Stainless steel 316/316L Other:Drain hole, vent hole: None Drain hole Vent hole Hole dimension:
Orifice flange Orifice assembly (orifice plate and orifice flange)
Flow nozzle
Meter run Integral orifice
Pitot tube (FloTec)
Venturi tube
Orifice plate
Model of primary flow element
1) Flange rating and sealing face see “Pipeline and piping class” (page 1)