Quadcopter Setup. 1. Fully charge batteries on Quadcopter, Remote Control and WiFi extender.

Quadcopter SetupQuadcopter Setup

1. Fully charge batteries on Quadcopter, Remote Control and WiFi extender.

2. Make sure propellers are tightened with a wrench.

3. Power up units in this order: 1. Remote Control2. WiFi extender3. Quadcopter

4. After powering up, wait until LEDs flash 10 times quickly for GPS setup.

5. Calibrate Compass before every flight at new location. Make sure you are not around any:-Power lines, Cell phones, large metal objects

6. Flick upper right switch up and down 5 times to enter compass calibration.

(compass calibrate)(compass calibrate)

7. Rotate Quadcopter 360 degrees horiz. and 360 degrees vertical (front down)

(compass calibrate)(compass calibrate)

8. Set Quadcopter on flat surface with red stripes (front) away from you .

9. Move both stick to the bottom and inward to start propeller motors.

10. Take off!

11. After landing, hold left stick down for 2 seconds to turn motors off.

12. After landing, power down units in this order: 1. Quadcopter

2. WiFi extender 3. Remote Control

Documents