Long HabitatRoof ridge support

Note: bar not levelCaused ridge vent caps to tilt toward

center

Should look like this

Note: with no support, bar not locking into place

Note: applying upward support causes bar to sit correctly

Elmer recommended drilling a second hole and installing an additional pin to lock bar in place.

Genset has rust issues that need to be resolved. Above photo is from left side of Genset, additional rust can be found inside the cable box.

Note: Rust was seen on inside of box on the bottom right side seam.

Note: This is the product used to re-fasten the labels on the containers.

Should check in Cayman to see how it held up and whether to use it again or try a different product.