Post on 21-May-2018
ONE COURSE FOR EVERY DIRECTION
Pipelay Barge ”Fortuna”
DUTCH MARINE CONTRACTORS
GENERAL INFORMATION
Length o.a.: 169 m Beam: 46 mDepth: 13,50 mOperating Draft / max.: 5 - 6.5 / 9 mGross Tonnage: 438 tNett Tonnage: 126 tAccomodation: 310
MAIN DIMENSIONS
Main generator sets: 4Capacity: 4 x 2500 kW / 440 V / 60 HzEmergency generator: 1Capacity: 1 x 315 kW / 440 V / 60 Hz
AUXILIARY SYSTEM
Single Drum Winch: 12 x 150 tonsRope diameter: 74 mRope length: 2500 mPull capacity / speed: 1100 tons / 24 m/minHolding Load: 400 tons (at 3rd Layer)Anchors: 12 x 20 tons, type Flipper Delta
MOORING SYSTEM
Stationary Tower Crane: 1 x 75 tons, LiebherrKobelco Crane: 1 x 250 tons Kobelco CKE 2500Staionary full-revolving aft deck crane: 1 x 1600 tons x 35 m (300 tons x 72 m) ZPMC
DECK EQUIPMENT
CONTACT
Phone: +31 20 3080 899Mail: info@dutchmarinecontractors.com
Web: www.dutchmarinecontractors.com
Vessel: FortunaType of vessel: Pipelay Barge / Multifunctional BargeYear of Build: 2010Modification: 2012Class: ABS / A1 Crane / Pipelay Barge with a ballast system
Details of the equipment offered by DMC is done in good faith and believed to be correct but cannot be guaranteed.
Pipe diameter: 6 to 60 inchesTensioners: REMACUT 2 x 100 tonsA&R Winch: REMACUT 1 x 200 tonsFiring Line: 6 welding stations, 1 NDT / repair station, 3 coating stations, 1 anode installation stationDavits: 6 x portside davits:central davits 4 x 80 tonsoutside davits 2 x 100 tonsStinger (L x B at tie-ins): 80 x 16 m, three sectionLay Radius: 150 to 350 m
PIPELY EQUIPMENT
ONE COURSE FOR EVERY DIRECTION
Pipelay Barge ”Fortuna”
DUTCH MARINE CONTRACTORS
COIL SYSTEM
Nominal tension: 20 tonsMax speed for unwinding: 1.200 m min conti-nuous and a crossing speed for winding 1000 m/h tube diameter / cable 50-600 mm
TENSIONER
CONTACT
Phone: +31 20 3080 899Mail: info@dutchmarinecontractors.com
Web: www.dutchmarinecontractors.com
Max. coil weight: 350 tonsMax. coil diameter: 11400 m Min. coil diameter: 8700 mCoil width: 5700 mMax linear tension: 15 tons at 5.7 m radiusMax speed for unwinding: 1200 m/h 5.7 m radiusMin speed for winding: 1200 m/h 5.7 m radius
Details of the equipment offered by DMC is done in good faith and believed to be correct but cannot be guaranteed.
ADITIONAL CABLE LAYING EQUIPMENT
Min. beding radius: 5.5 m Vertical load: 5 tons
INLET CHUTE
Min. beding radius: 8.3 mTotal angle converges with the through 110 degrees
OUTBOARD CHUTE