Post on 17-Jan-2018
description
PestPac GPS
PestPac GPS Garmin Functionality & Dispatching
PestPac GPS Control Panelhighlighting Job Status’ from Garmin devices
Update Garmin for Dispatch FunctionalityYour Garmin unit comes with preloaded firmware that will need to be updated to function properly with our Dispatching & Messaging features. You will need to download the free WebUpdater software tool from Garmin to your PC.
To download Garmin’s WebUpdater software, visit http://www8.garmin.com/products/webupdater/howtoinstall.jsp
Once downloaded on your PC, use the supplied USB cable provided by Garmin to install the latest firmware for your particular Nuvi or Dezl device. Connect your Garmin device to your PC and run WebUpdater. Once the firmware is updated, simply disconnect USB cable and you’re set to install Garmin’s in vehicles.
Assure the latest firmware has been loaded onto your Garmin device(s) by connecting to GPS device installed in vehicles. If the Dispatch screen (right image) appears the update was successful! If the standard Where To? screen shows (left image), try updating firmware on device again by following steps above.
Standard Nuvi Screeen
Garmin WebUpdater Tool
Updated Dispatch Screen
First things first…
Update Driver ID
Select Dispatch
Orders Received Notification
Alerts Technician of new orders received on Garmin
Alerts Technician of pending message from officeClicking on “Flag” takes Technician to
Orders Screen
Today’s Orders from PestPac are listed in order
Select 1st Order and Click “Go!”“Go!” will provide turn-by-turn directions to stop.
“Go” will also show “En Route” in PestPac for staff to know Tech’s status.
Route Calculates…
“Edit Stop” to show “On-Site” or update Status if not able to service account
Click on Edit Stop to update Status of order.
After Arriving at Customer site, “Mark as Done”
“Mark as Done” to let people in the office know that you’re “On-Site”, that you are at the customer’s location.
Or choose a different status…
Informs office if you did not service or…
Driver Status info also alerts staff of Tech or Job status in PestPac
Return to Dispatch Screen
To start driving to next stop…
Job Shows as Completed, Select Next Job
Select 2nd Order and Click “Go!”“Go!” will automatically alert “Service Complete” on the previous job while showing “En Route” to the new job.
PestPac GPS Control Panelhighlighting Job Status’ from Garmin devices