MS35207FAMENDMENT 229 SEPTEMBER 1999

MILITARY STANDARD

SCREW, MACHINE-PAN HEAD, CROSS-RECESSED,CARBON STEEL, CADMIUM PLATED, UNF-2A (IN/MM)

This amendment forms a part of MS35207F, dated 21 MAY 1969,and is approved for use by all Departments and Agencies of theDepartment of Defense.

Under Requirements:

Under Protective Coating, add the following option:

ZINC COATING IN ACCORDANCE WITH ASTM B633-78, Fe/Z η 5 (5µm), TYPE II.

Under Part Number, add the option for Zinc Plating:

6. PART NUMBER: THE PART NUMBER SHALL CONSIST OF THE BASI MS NUMBERFOLLOWED BY A DASH NUMBER FROM TABLE I, FOLLOWED BY A PROTECTIVE COATINGCODE.

MS35207 - 201 Z

PROTECTIVE COATING CODE Z INDICATES ZINC COATING NO CODE INDICATES CADMIUM PLATING

DASH NUMBER

BASIC MS NUMBER

MS35207-201Z INDICATES – SCREW, MACHINE-PAN HEAD, CROSS-RECESSED,CARBONSTEEL, ZINC COATED, .086-56, UNC-2A, .125 LENGTH.

Custodians: Preparing Activity: Army - AR DLA-IS Navy - AS Air Force - 82 (Project 5305-2401)

AMSC N/A FSC 5305DISTRIBUTION STATEMENT A. Approved for public release; distribution isunlimited.

INCH-POUND

Downloaded from http://www.everyspec.com