Post on 15-Mar-2018
1/3 49 669
MiG-25PD/PDS Foxbat interior S.A.
49 6691/48 scale detail set for Kitty Hawk kit • sada detailů pro model 1/48 Kitty Hawk
ORIGINAL KIT PARTSPŮVODNÍ DÍLY STAVEBNICE
PHOTO-ETCHED PARTSLEPTANÉ DÍLY
PARTS TO BE REMOVEDDÍLY K ODSTRANĚNÍ
FILLTMELIT
eduard
REMOVEODSTRANIT
OPTIONVOLBA?REPLACENAHRADIT
BENDOHNOUT
GRINDOBROUSIT
SYMETRICAL ASSEMBLYSYMETRICKÁ MONTÁŽ
DRILL HOLEVRTAT OTVOR
APPLY EXPRESS MASK AND PAINT BEFORE GLUINGPOUŽÍT EXPRESS MASK NABARVIT PRED SLEPENÍM
1 COLORED ETCHED PARTSLEPTANÉ BAREVNÉ DÍLY
27
H37
=
PE7
45
39
38
48
H16, H49, H52
53
8
12
11
13
146
16
9
4
4
10
PE6
7
15
24
H57
34
33
PE5
31
18
17 47
46
23
H53
H14
H12H54
3
2
1
25
26
PD18
52
© EDUARD M.A. 2014 www.eduard.com Made in Czech Republic
2/3 49 669
eduardFor further detail sets look for 48 797 MiG-25PD/PDS Foxbat exterior(not included in this set)
19
28
22
30
G14
5 20
21
32
29
G12
50
43
42D3
F14
F13H15
eduardFor further detail sets look for 48 797 MiG-25 R-40 missiles detail set(not included in this set)
eduardFor further detail sets look for 48 808 MiG-25 Foxbat F.O.D+ air intake(not included in this set)
49GP2
44
35
36
37
37
40
41
GP1
51
51
51
51
3/3 49 669
2. Do not inadvertently place etched componets on an unwanted surface. Attempts to remove will result in damage to your part.
2. Nepokládejte samolepící díly na volné plochy. Pokud je omylem přilepíte, při pokusu o odlepení dojde k poškození dílu.
3. Do not touch the adhesive areas of the etched components.
3. Nesahejte na části dílů, na kterých je naneseno lepidlo.1. Separate the etched components from their frames on the protective paper. Removal from the paper is done only after separation of the parts from the frames.
1.Samolepící díly oddělujte od rámečku na podkladovém papíře. Po oddělení je sejměte z krycího papíru.
4. Hold the parts by the edges, or at areas free of adhesive.
4. Samolepící díly berte za hrany nebo za části, na kterých není nanesené lepidlo.
5. Lightly place the component in the desired location and position. Adjust as required. The component will be permanently affixed when pressed onto its intended location, its location can be adjusted.
5. Díl lehce položte do pozice, ve které má být nalepen. Upravte přesnou pozici a přimáčkněte. Díl dokonale přilne až po přimáčknutí, před přimáčknutím lze dílem opatrně manipulovat.
PARTS WITH GLUE DÍLY OPATŘENÉ LEPIDLEM