Post on 27-May-2020
Extremely low, 1.5” profilemaximizes vehicle clearance
1.5”
Available in two sizes:16” x 16“ and 20” x 20”.
Quick-connect plugs makeconnection/disconnectionsafe and easy
Stiffening brackets preventdeck sagging
Discreet weep holes prevent water from collecting on the fixture.
Allows for installation in 4 - 6.5”openings. Additional options available by request to replace virtually any existing fixture.
Versatile.
Water resistant. Retroplate accessory. Easy installation.
Low profile. Durable design.
Typical fuel station layouts
MASI 16" x 16"• Select from three lumen packages
• Replace 100W - 250W metal halide fixtures
• Use in typical canopy applications with mounting heights from 10‘ - 16’
14’
18’
MASI is designed for installation in canopies with single-deck construction (access to junction box from above the canopy is required).
Standard 4” Hole Installations:
1. Disconnect and remove old fixture (if applicable) and insert the wires and mounting stem on the MASI through the hole.
2. Two spring clips on the stem compress while being fed through the hole and spring back to secure the fixture in place once the stem is pushed entirely through the opening.
3. Installation is completed from the top of the canopy by bolting the junction box to the stem, wiring the fixture and latching the cover to the junction box.
Mounting stem with spring clips
Water-resistantjunction box
Luminaire spacing criterion (SC) is 1:1 based on canopy height in driving lanes. Average illumination is 10 - 20 fc.
MASI 20" x 20"• Select from two lumen packages
• Replace 320W - 400W metal halide fixtures
• Use in canopies with higher mounting heights from 16' - 24’ in applications such as industrial fueling stations and truck stops along major roadways
Additional retrofit options: An optional retroplate allows for installation in openings from 4 - 6.5” in diameter. Additional retrofit options are available upon request to replace virtually any existing fixture. Please contact RAB Customer Service 1-888-722-1000.
16 1/8”409 mm
16 1/8”409 mm
MASI RETROPLATEOptional retroplate allows for installation in openings from 4 - 6.5” in diameter. Additional retrofit options available upon request to replace virtually any existing fixture.
/D10
Driver Options
/D10 120-277V with 0-10V Dimming (standard, not optional)/480 480V On/Off Driver (replaces /D10 suffix)