Manual Avensis

AUDIOTOYOTA GENUINE AUDIO

NOTICE EXPLICATIVE DE L’INSTALLATION

Avensis

FÜR-FOR-POUR **T25*R

Binder Volume 4Manual Ref.no A4RT25/J-0-0

Avensis (T25) TOYOTA GENUINE AUDIO

Avensis (RHD) - 3 10-02

1. Application Chart ............................................................................................................................................................................ 4

2. System Layout .............................................................................................................................................................................. 5

3. In-dash 6 CD-Changer Installation ................................................................................................................................................. 6

4. Hide-away 6 CD-changer installation .............................................................................................................................................. 15

1. TABLE OF CONTENTS

ire (0

Unique Design Audio

p. 1/1

NOTE:The installation position of the hide-away 6 CD-changer in under the driver seat.12

THE HIDE-AWAY 6 CD-CHANGER

2. SYSTEM LAYOUT

Avensis (RHD) - 610-02

Fig. 1

Fig. 2

1. Remove the shift knob and shiftcover using a nylon pry tool.

: Clip (4x): Nail (4x)

3. Attach the protection tape .4

Fig. 3

2. Remove the panel .: Clip (5x)

3. IN-DASH 6 CD-CHANGER INSTALLATION

4. Remove the audio unit .: Bolt (4x)101

Fig. 4

6.a) Remove the switch .b) Remove the bulb .c) Remove the connector by moving it

upward.27

Fig. 5

Fig. 6

5. Remove the glove compartment .a) Remove the hooks .

: Hook (2x)b) Remove the stoppers by pulling

them inside.28

104104

104 104

Fig. 7

Fig. 8

Approximately 1

7. Cut the tape into 10 equal pieces.5

8. Relocate the vehicle connectorposition from location “A” to location“B”and attach the connector to the har-ness using tape and a wire tie .

: Wire tie (1x)20

“A”

“B”

Harness

Fig. 9

9. Route and attach the changer wire using wire ties .

: Wire tie (3x)20

Fig. 10

10. Route the changer wire using wireties and wrap the connectors usingtape .

: Tape 2x (3x): Wire tie (2x)20

Connect

To audio

Vehicle harness

To audio

AVC-LAN wire harness

Wire of changer unit

WITH POP UP DISPLAY

Do not connect

WITHOUT POP UP DISPLAY

Do not connect

11. Cut the template (312N) (see page22, 23) using scissors.

Fig. 11

13. Use protection tape in order not todamage the surface of the dashboard.

Fig. 13

Fig. 12

12. Mark the dashboard using the template(312N) .7

Corner fits

Marking

Corner fits

Marking

Drill a hole of 10mm

Hole fit

14. Cut the marked position on the dash-board using a saw.

Fig. 14

Fig. 15

16. Temporary attach the screws in theexisting holes.

: Screw (M6x12) (2x)106

Fig. 16

15. Cut the marked position on the dash-board using a saw.

Existing holes

Reinforcement pipe

17. Fit the side bracket (L) and (R) ontothe changer unit .

: Bolt (M5x8) (4x)10

Fig. 17

Fig. 18

19. Cut the glove compartment .6

Fig. 19

18.a) Fit the switch .b) Fit the in-dash changer unit .

: Screw (M6x12) (2x): Screw (M6x14) (2x)23

Existing marking

Connector

Blanket

20. Fit the glove compartment .: Hook (2x)104

Fig. 20

21. Cut the panel .3

Fig. 22

22. Fit the panel .3

Fig. 23

Fig. 24

Fig. 25

Fig. 26

3. Attach the protection tape .4

2. Remove the panel .: Clip (5x)

1. Remove the shift knob and shiftcover using a nylon pry tool.

: Clip (4x): Nail (4x)

3. HIDE-AWAY 6 CD-CHANGER INSTALLATION

4. Remove the audio unit .: Bolt (4x)101

Fig. 28

5.a) Remove the cover .

: Screw (2x)b) Remove the centre console .

: Screw (4x): Bolt (4x)107

Fig. 29

107107

8. Cut the tape into 10 equal pieces.5

Fig. 32

a) Remove the front door scuff plate (R). : Nail (5x)

b) Remove the kick panel (R).: Nut (1x)103

Fig. 30

7. Remove the driver seat .: Bolt w/washer (4x)

: Cover (2x)11106

Fig. 31

Fasten the bolt with specified torquewhen reassembling.

CAUTION

10. Route and attach the changer wire using tape (1x).5

Fig. 34

9. Route the changer wire and wrapthe connectors using tape .

: Tape (2x3)5

Fig. 33

Vehicle Harness

To audio

AVC-LAN wire harness

WITH POP UP DISPLAY

WITHOUT POP UP DISPLAY

Do not connect

12. Cut the carpet at the changer unitattachment position on the driver side.

Fig. 36

11.a) Route the changer wire along the

cross member and attach usingtape (4x).

b) Attach the excess wire of the changerwire onto the cross memberusing tape (6x).5

Fig. 35

Cut area

Centre console

Cross member Positioning hole driver seat

Excess wire

Vehicle harness

14. Attach the base bracket on the flooron the driver side.

Fig. 38

13. Attach the adhesive tapes and thespacers ( and ) to the base brack-et using screws .

: Spacer (w/o nut): Spacer (w/nut): Tape (1x)*: Tape (cut to size 67mmx50mm) (1x): Screw (M5x16) (2x)8

871615

Fig. 37

Fig. 39

16. Fit the changer unit .

a) Connect the changer wire to thechanger unit .

b) Mount the changer unit onto thebase bracket using screws .

: Bolt (M5x10) (4x)105

Fig. 40

ENSURE THAT ALL REMOVED CONNECTORS AREPUT BACK CORRECTLY.

REFIT THE TRIM AND REMOVED PARTS.

Hole position on the left side

15. Mount the side brackets (2x) to thechanger unit .

: Bolt (M5x8) (4x)10

Loosen the screws before movingthem. Tighten up after the position ischanged.

CAUTION

Hole position on the right side

CAUTION

Avensis (T25)

Cut line precisely

Cut line preC

ut line precisely

Cut line precisely

Cut a long hole

Cut line

TOYOTA GENUINE AUDIO

eciselyCut line precisely

Cut line precisely

precisely

Cut line

312N TEMPLATE

TOYOTA MOTOR CORPORATION

Manual Avensis

Documents

Transcript of Manual Avensis

Toyota Avensis (T25)

TOYOTA AVENSIS - Toyota UK Media Sitemedia.toyota.co.uk/.../13209534451319284842pack.pdf · TOYOTA AVENSIS KEY POINTS ... • Six-speed manual and Multidrive S continuously variable

AVENSIS IN GRAPHITE - Toyota NZ Avensis features a smooth Continuously Variable Transmission (CVT) with 7-speed sport sequential manual mode. For an even more engaging drive,

Katalog Avensis

65’ Toyota Avensis 2009» Toyota Avensis Kombi 2009» · 65’ Toyota Avensis 2009» Toyota Avensis Kombi 2009» 664-0620 00-3014

Avensis Wagon (LHD) Avensis Sedan (LHD) - Toyota€¦ · 06DE4043C Avensis Wagon (LHD) Avensis Sedan (LHD) TPA Front Installation instructions Model year: 2015/05 Vehicle code: **T27*L-A****W

Avensis Wagon (LHD) Avensis Sedan (LHD) - toyota … · 06DE4043C Avensis Wagon (LHD) Avensis Sedan (LHD) TPA Front Installation instructions Model year: 2015/05 Vehicle code: **T27*L-A****W

Print Now » | X Close Window TOYOTA2003-2007 TOYOTA Avensis - 5 Puertas 1998-2003 TOYOTA Avensis Familiar 2009-2011 TOYOTA Avensis Familiar 2007-2009 TOYOTA Avensis Familiar 2003-2006

Avensis - ToyotaC6CD756D-FB0D-2F33-A7DF-A980… · Avensis Front fog lamp (pre-wired vehicles) Installation instructions Manual reference number: AIM 000 585-0 Model year: 04/2006

Avensis Wagon (LHD) Avensis Sedan (LHD) - Toyota-Tech.eu

Avensis Produktinformation

LIGHTING AVENSIS

M14 x 2 pieces - TanieMoto.comFOR TOYOTA AVENSIS (4/5D), (T22) FITTING AND OPERATION MANUAL. ( 1997 - 04/2003 r. ) DESTINATION -100 for Toyota Avensis (4/5D) Toyota Avensis (4/5D)

Avensis Verso

65’ Toyota Avensis 2009» Toyota Avensis Kombi 2009»Secure Site · 65’ Toyota Avensis 2009» Toyota Avensis Kombi 2009» 664-0620 00-3014

Avensis Wagon (LHD) Avensis Sedan (LHD) - Toyota …C86DAF4A-2AE5-7327-BF3A-C94CC0… · Avensis Wagon (LHD) Avensis Sedan (LHD) TPA Front Installation instructions Model year: 2008

Toyota Avensis Forum

ENGINE MECHANICAL REPLACEMENTnaula.sytes.net/~naula/Avensis/Esquemas corolla y avensis/Toyota_Repair_Information.pdfENGINE MECHANICAL– PARTIAL ENGINE ASSY(1ZZ–FE/3ZZ–FE) AVENSIS