Magic Bullet NutriBullet Pro Power CordReplacement

This guide will walk you through the steps necessary to replace the power cord in your MagicBullet Nutri Bullet Pro.

Written By: Malcolm Smith Fraser

Magic Bullet NutriBullet Pro Power Cord Replacement Draft: 2016-12-22Guide ID: 72308 -

This document was generated on 2019-09-25 06:50:20 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 4

INTRODUCTION

If your Magic Bullet Nutri Bullet Pro is not receiving power as a result of a faulty power cord, use thisguide to replace the power cord. To use his guide, first follow steps one and two of the disassemblyguide.

TOOLS:Phillips #0 Screwdriver (1)

Magic Bullet NutriBullet Pro Power Cord Replacement Draft: 2016-12-22Guide ID: 72308 -

This document was generated on 2019-09-25 06:50:20 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 4

Step 1 — Power Cord

Follow steps one and two fromMagic Bullet NutriBullet ProDisassembly before following thesenext steps.

Step 2

Cut the zip tie using scissors.

Magic Bullet NutriBullet Pro Power Cord Replacement Draft: 2016-12-22Guide ID: 72308 -

This document was generated on 2019-09-25 06:50:20 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 4

To reassemble your device, follow these instructions in reverse order.

Step 3

Pull off the rubber covers andseparate the wires using a solderingkit.

Magic Bullet NutriBullet Pro Power Cord Replacement Draft: 2016-12-22Guide ID: 72308 -

This document was generated on 2019-09-25 06:50:20 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 4