Solar air conditioner installation Instruction

The solar air conditioner must be installed by skilled technicians. In addition ,the people should make sure that the working conditions are safe!

Indoor unit installation

2. Please open the packaging, and you will see indoor unit 、outdoor unit and vaccum tubes etc.

4. Please prepare these tools for installation: • a Screw driver ;

• Two Spanners ;

• 5# inner hexagon spanner ;

• Some soap water ;

Indoor unit installation

As the outdoor water tank of solar air conditioner needs to collect the drain water from indoor unit, so the installation position of indoor unit must be higher than outdoor unit.

Indoor unit installation

Use the four expansion screws to mount the hang board on the wall

You will see two copper nuts and a drain water tube at back of the indoor unit.

First, you need use spanners to loose the nuts

Indoor unit installation

use spanner to connect two connecting copper tubes

To twist off the cap of the connecting tubes

Indoor unit installation

To connect the water drain plastic tube with the indoor unit

Lift the electric wiring at the same direction with the water drain tube.

Indoor unit installation

To use the plastic belting to warp the connecting tubes and the electric wiring and the water drain tube. then through all of them to the outdoor

Then to hang the indoor unit on the wall.

Indoor unit installation

Outdoor unit installation

To use spanner fix four stainless steel screws at the front plate of the outdoor unit, and it needs to reserve 2mm distance between the screw and the front plate

Outdoor unit installation

To fix the left and right tank support brackets on the front plate of the outdoor unit,and tighten the screws

Outdoor unit installation

To put the water tank on the support brackets,and use two nuts fix the water tank

Outdoor unit installationPut the rubber ring to each vaccum tubes

Dip some soap water at terminal of the vacuum tubes, it helps install the vaccum tube

Then insert the vaccum tubes to the water tank

Outdoor unit installation

insert all vaccum tubes in water tank

Connect and seal the vacuum tubes with the rubber rings.

Outdoor unit installation

put the plastic footstock to each hole on the vaccum tube support

To insert all tubes to vaccum tube support

Outdoor unit installation

To use four screw nuts to fix the vacuum tube support

To adjust the right position of the vacuum tubes between the water tank and the vacuum tube support

Outdoor unit installation

To lift all rubber rings closed to the water tank

Outdoor unit installation

To put the air vent to the top of the water tank

To install the water connect plastic tube at side of water tank

Outdoor unit installation

To use spanner remove the cap of the stop valve

Outdoor unit installation

To remove the nuts caps of the water tank

Outdoor unit installation

To use the two connecting tubes connect to the stop valves and the nuts of water tank

Outdoor unit installation

To use the tap warp the two tubes

Outdoor unit installation

To connect two connecting tubes which from indoor unit.

To use the tap warp these two tubes.

Outdoor unit installation

To use the screw driver remove the plastic cover on the outdoor unit

To use the screw fix the wiring from indoor unit

Outdoor unit installation

To connect the water drain tube from the indoor unit

To connect the other plastic water tube on the water tank, it is used for drain the water ,when the water tank was full

Outdoor unit installation

At last ,you need to use 5# inner hexagon spanner to open the stop valves to get out of the air of the connecting tubes. It's like install a normal air conditioner

After all installation instructions are finished, please fill the water tank full with water from this hole.

Outdoor unit installation