GeoBee! LDK

Library Development Kit

Doodle Sheets

• Use these models to sketch out your own library.

• Take your sketches, then diagram them using the templates slides at the end of this slide set.

• Remember, you will also need to submit a Library Definition Sheet with your library slides. The Library Definition Sheet can be found as part of the LDK file package.

Anchor Point is Active and Invisible

Anchor Point is Active and Visible

Anchor Point is Inactive and Invisible

Anchor Point is Inactive and Visible

Line Segments (copy/paste)Anchor Points (copy/paste)

Templates

• Select a 3x3, 4x4, or 5x5 template from the coming slides. There are two of each, one as a backup.

• Duplicate your slide, and use the duplicate as your drawing board.

• Copy/paste design elements from the following page onto the following library templates.– One slide per pattern.

Anchor Point is Active and Invisible

Anchor Point is Active and Visible

Anchor Point is Inactive and Invisible

Anchor Point is Inactive and Visible

Line Segments (copy/paste)Anchor Points (copy/paste)

Pattern Name:

Pattern Time

Pattern Name:

Pattern Time

Pattern Name:

Pattern Time

Pattern Name:

Pattern Time

Pattern Name:

Pattern Time

Pattern Name:

Pattern Time

Submitting the Library• When you have completed your library:– Order your slides in the order they should appear in

your final library. – Note: Only one slide per library pattern.– Limit of 40 slides per pattern.

• Email a copy of the following information to info@visionmechanic.com for approval: – Your library (slides of your library) as a PowerPoint– Your Library Definition Sheet

• You will be notified when your library is ready, or if changes are required.