Post on 04-Sep-2018
Expedient Homemade Firearms
.32/380 Machine Pistol MKII
Expedient Homemade Firearms
.32/380 Machine Pistol MKII
Expedient Homemade Firearms
The upper and lower receiver
assembly (Measurements in millimetres)
With the upper and lower receiver assembly clamped together with two hose clips, the upper receiver must overlap the lower by 6mm, as shown at ‘A’. The slot for the trigger ‘B’, is positioned 58mm from the rear end of the receiver and is 17mm in length. The slot for the trigger guard, ‘C’, is positioned 51mm from the front of the receiver and is 3mm in length and 12.7mm (1/2”) in width.
Hose Clips
.32/380 Machine P
istol MK
II
LOWER RECEIVER ASSEMBLY
The trigger guard, grip, and socket screws are secured in place using silver solder at points ‘a’ ‘b’ ‘c’ and ‘d’. The socket screw ‘d’ allows the sear spring to be attached to the receiver.
Expedient Homemade Firearms
TEMPLATES
.32/380 Machine Pistol MKII
FULL
Y A
SS
EM
BLE
D L
OW
ER
RE
CE
IVE
R
Expedient Homemade Firearms
.32/380 Machine Pistol MKII
Expedient H
omem
ade Firearms
.32/.380 Machine Pistol Mark II
This schematic drawing shows the simplicity of the MKII design.