Post on 04-Jan-2016
Eeng 360 1
Chapter 5
AM, FM, and Digital Modulated Systems
Phase Modulation (PM) Frequency Modulation (FM) Generation of PM and FM Spectrum of PM and FM Carson’s Rule Narrowband FM
Huseyin BilgekulEeng360 Communication Systems I
Department of Electrical and Electronic Engineering Eastern Mediterranean University
Eeng 360 2
AAM and FM M and FM Modulation Modulation
(a) Carrier wave. (a) Carrier wave.
((bb) Sinusoidal modulating signal. ) Sinusoidal modulating signal.
(c) (c) Amplitude-modulated signal.Amplitude-modulated signal.
(d) Frequency modula(d) Frequency modulated signal.ted signal.
Eeng 360 3
Angle Modulation Angle Modulation
We have seen that an AM signal can be represented as
ttmAts c ccos )](1[)(
Now we will see that information can also be carried in the angle of the signal as
Note that in this type of modulation the amplitude of signal carries information.
ttAts cc cos
Here the amplitude Ac remains constant and the angle is modulated.
This Modulation Technique is called the Angle Modulation
Angle modulation: Vary either the Phase or the Frequency of the carrier signal
Phase Modulation and Frequency Modulation are special cases of Angle Modulation
Eeng 360 4
Angle Modulation Angle Modulation Representation of PM and FM signals:
The Complex Envelope for an Angle Modulation is given by tjceAtg
cAtgtR Is a constant Real envelope,
θ(t) - linear function of the modulating signal m(t)
The Angle-modulated Signal in time domain is given by ttAts cc cos
g(t) - Nonlinear function of the modulation.
Special Case 1: For PM the phase is directly proportional to the modulating signal. i.e.;
Where Dp is the Phase sensitivity of the phase modulator, having units of radians/volt.
Special Case 2:For FM, the phase is proportional to the integral of m(t) so that
where the frequency deviation constant Df has units of radians/volt-sec.
Eeng 360 5
Angle Modulation Angle Modulation
)](cos[)( tmDtAts pcc Resulting PM wave:
Phase Modulation occurs when the instantaneous phase varied in proportion to that of the message signal.
tmDt p Dp is the phase sensitivity of the modulator
Frequency Modulation occurs when the instantaneous frequency is varied linearly with the message signal.
)()( tmDt fci
t
f dmDt
] )([cos)(
t
fcc dmDtAts Resulting FM wave:
Df is the frequency deviation constant
Instantaneous Frequency (fi) of a signal is defined by
dtdt
tdt
t
ii )(
)( where ttt c
Eeng 360 6
Phase and Frequency ModulationsPhase and Frequency Modulations
• Phase Modulation • Frequency Modulation
Comparing above two equations , we see that if we have a PM signal modulated
by mp(t), there is also FM on the signal, corresponding to a different modulation
wave shape that is given by:
Similarly if we have a FM signal modulated by mf(t),the corresponding phase
modulation on this signal is:
Where f and p denote frequency and phase respectively.
Eeng 360 7
t
fp
fp dm
D
Dtm
dt
tdm
D
Dtm p
f
pf
Integrator Phase Modulator (Carrier Frequency fc)
Differentiator Frequency Modulator (Carrier Frequency fc)
Generation of FM from PM and vice versa Generation of FM from PM and vice versa
tm p
tm f tm p
tm f
ts
ts
FM Signal
PM signal
Generation of FM using a Phase Modulator:
Generation of PM using a Frequency Modulator:
Gain f
p
D
D
Gain f
p
D
D
Eeng 360 8
FM with sinusoidal modulating signal FM with sinusoidal modulating signal
The Instantaneous Frequency of the FM signal is given by:
dt
tdftftf cid
21
The Peak Frequency Deviation is given by:
dt
tdF
21
max
The Frequency Deviation from the carrier frequency:
The Peak-to-peak Deviation is given by
dt
td
dt
tdFpp
2
1min
2
1max
∆F is related to the peak modulating voltage by pfVDF21
tmVp maxWhere
1
2i c
d tf t f
dt
If a bandpass signal is represented by: )( ttt c
Eeng 360 9
FM with sinusoidal modulating signal FM with sinusoidal modulating signal
dt
tdftf ci
21
But,
Vp BW
Average Power does not change with modulation
2PowerAverage
2cA
Eeng 360 10
Angle Modulation Angle Modulation
Advantages:
Constant amplitude means Efficient Non-linear Power Amplifiers can be used.
Superior signal-to-noise ratio can be achieved (compared to AM) if bandwidth is sufficiently high.
Disadvantages:
Usually require more bandwidth than AM
More complicated hardware
Eeng 360 11
Modulation Index Modulation Index
The Peak Phase Deviation is given by: t max
∆θ is related to the peak modulating voltage by: ppVD tmVp maxWhere
The Phase Modulation Index is given by: pWhere ∆θ is the peak
phase deviation
The Frequency Modulation Index is given by:
B
Ff
∆F Peak Frequency Deviation
B Bandwidth of the modulating signal
Eeng 360 12
Spectra of Angle modulated signals Spectra of Angle modulated signals
Spectra for AM, DSB-SC, and SSB can be obtained with simple formulas relating S(f) to M(f).
But for angle modulation signaling, because g(t) is a nonlinear function of m(t). Thus, a general formula relating G(f) to M(f) cannot be obtained.
To evaluate the spectrum for angle-modulated signal, G(f) must be evaluated on a case-by-case basis for particular modulating waveshape of interest.
cc ffGffGfS
2
1
tjceAtgfG Where
Spectrum of Angle modulated signal
Eeng 360 13
Spectrum of PM or FM Signal with Sinusoidal Modulating Signal Spectrum of PM or FM Signal with Sinusoidal Modulating Signal
Assume that the modulation on the PM signal is
tAtm mmp sin tt m sinThen
mpp ADWhere is the phase Modulation Index.
Same θ(t) could also be obtained if FM were used
tAtm mmf coswhere
mmff AD /
mf ADF21
The Complex Envelope is:
and
The peak frequency deviation would be
tjc
tjc
meAeAtg sin which is periodic with periodm
m fT
1
Eeng 360 14
Using discrete Fourier series that is valid over all time, g(t) can be written as
n
n
tjnn
mectg
2
2
sinm
m
mmT
T
tjntj
m
cn dtee
T
Ac
Where
nc
njcn JAeAc
sin
2
1Which reduces to
Jn(β) – Bessel function of the first kind of the nth order
Taking the fourier transform of the complex envelope g(t), we get
nn
n JJ 1 Is a special property of Bessel Functions
Spectrum of PM or FM Signal with Sinusoidal Modulating Signal Spectrum of PM or FM Signal with Sinusoidal Modulating Signal
n
nmn nffcfG or
n
c n mn
G f A J f nf
Eeng 360 15
Bessel Functions of the First Kind Bessel Functions of the First Kind
J0(β)=0 at β=2.4, 5.52 & so on
Eeng 360 16
Bessel Functions of the First Kind Bessel Functions of the First Kind
Eeng 360 17
])cos[()()( tnJAtS mn
cnc
The FM modulated signal in time domain
From this equation it can be seen that the frequency spectrum of an FM waveform with a sinusoidal modulating signal is a discrete frequency spectrum made up of components spaced at frequencies of c± nm.
By analogy with AM modulation, these frequency components are called sidebands.
We can see that the expression for s(t) is an infinite series. Therefore the frequency spectrum of an FM signal has an infinite number of sidebands.
The amplitudes of the carrier and sidebands of an FM signal are given by the corresponding Bessel functions, which are themselves functions of the modulation index
Observations:
Frequency spectrum of FM Frequency spectrum of FM
Eeng 360 18
Spectra of an FM Signal with Sinusoidal ModulationSpectra of an FM Signal with Sinusoidal Modulation
BT
cA
fS
2
1
)(
f
1.0
The following spectra show the effect of modulation index, , on the bandwidth of an FM signal, and the relative amplitudes of the carrier and sidebands
Eeng 360 19
BT
J0(1.0)
J1(1.0)
J2(1.0)
cA
fS
2
1
)(
f
1.0
Spectra of an FM Signal with Sinusoidal ModulationSpectra of an FM Signal with Sinusoidal Modulation
Eeng 360 20
BT
cA
fS
2
1
)(
f
1.0
Spectra of an FM Signal with Sinusoidal ModulationSpectra of an FM Signal with Sinusoidal Modulation
Eeng 360 21
Although the sidebands of an FM signal extend to infinity, it has been found experimentally that signal distortion is negligible for a bandlimited FM signal if 98% of the signal power is transmitted.
Based on the Bessel Functions, 98% of the power will be transmitted when the number of sidebands transmitted is 1+ on each side.
Carson’s ruleCarson’s rule
(1+fm
Eeng 360 22
Carson’s ruleCarson’s rule Therefore the Bandwidth required is given by
β – phase modulation index/ frequency modulation index
B – bandwidth of the modulating signal
mT fB 12
For sinusoidal modulationmfB
Carson’s rule : Bandwidth of an FM signal is given by
Note: When β =0 i.e. baseband signals mT fB 2
2 1TB B
Eeng 360 23
Narrowband Angle ModulationNarrowband Angle Modulation Narrowband Angle Modulation is a special case of angle modulation where θ(t) is restricted to a small value.
rad 2.0)( t
The complex envelope can be approximated by a Taylor's series in which only first two terms are used.
tjAtg c 1
jceAtg
ttAtAts cccc sincos
]1xfor 1 because [ xe xbecomes
The Narrowband Angle Modulated Signal is
The Spectrum of Narrowband Angle Modulated Signal is
ccccc ffffjffff
AfS
2
.2
,
fMfj
D
fMD
tf f
p
where
PM
FM
Eeng 360 24
Indirect method of generating WBFMIndirect method of generating WBFM
Balanced Modulator ttAtAts cccc sincos
Eeng 360 25
Wideband Frequency Wideband Frequency modulationmodulation
Eeng 360 26
FM Stero SystemFM Stero System
Eeng 360 27
FM Stero SystemFM Stero System