ß1Tutorial manufacturing of trainning staff Burno for Burncrewconcept.net

Tutorial Staff: trainning

Materials?

8 1 wooden bar-type curtain rod (recommended Ø 28mm / length 1m 40)

8 2 pieces of «pool noodle ‘(2 x 14 cm) 8 1 Bicycle grip for handles (1 roll) 8 1 roll of large scotch

8 Tools? 8 A saw /! \ Make sure your fingers /! \ 8 A silicone gun 8 A metal tube of the Ø of your sleeve 8 scissors 8 a marker 8 meter

a Ideal for beginners, «strong and gentle», this training props is designed to allow you to learn and to work calmly.

Tutorial manufacturing of trainning staff Burno for Burncrewconcept.netß2

How to do ? 8 Trim your «curtain rod»

to the desired length by 140 cm and its center was 70cm.

8 Mark the center by 70 cm. For a spinning staff measuring 20 cm on each side of the center.

8 Prepare your marks to ask grip.

8 To contact a staff, measuring 30 cm on each side of the center (the cap)

ß3Tutorial manufacturing of trainning staff Burno for Burncrewconcept.net

8 Cut thechips in pieces of 14 cm long

8 Pierce the chips in the middle with the metal tube

8 Close the extremity with a large scotch

Tutorial manufacturing of trainning staff Burno for Burncrewconcept.net

8 Fulfill the third of silicone sealant (1/3 hole) and push the bar

8 Fix the grip on your bea-rins in diagonal overlay

ß4

8 Cover the extremities of the grip by the large tape.

8 Et voilà !

ß5Tutorial manufacturing of trainning staff Burno for Burncrewconcept.net