ARCHITECTURE DESIGN STUDIO AIR

JOURNAL

DEGUO HOU (JACK)387313

Boolean patterning combin with image sampler and Data driven rotation

Boolean patterning combin with im-age sampler and Data driven extruc-sion

Explicit Grids combin with image sampler and preview

Surface Grids combin with image sampler and Data driven Extrucsion

Boolean patterning combin with Attractor point and Data driven extrucsion

Surface Grids combin with Attractor point and Circle

Arbitrary points combin with image sampler and Data driven Rotation

Boolean patterning combin with image sampler and Data driven Rotation

Boolean patterning combin with image sam-pler and Data driven Rotation

Following the CUT definitions, I took some part of inpput out and combine with others, try to work out a complex and well-look model. What I found interstesting is the image samper, and the rotation and extruction. By combine all those different input, association and output togeter, now I get better knowledge about grasshooper, and quite enjoy it. However, most output I found are in a geomtric of circle, when I trying to build a rectangle or triangle, I found difficult to do that, and actually I’m faild. The last model looks quite simple, with this one, I tried to relate to our next proj-ect- Gateway, what I did is first create a surface and try to use CUT to create a bunch of small open-ings and then by using data driven rotation to rotate its direction to different ways, however, as I just mentioned earlier, I’m failed to do that as I cannot create a rectanangle and triangle in grasshooper. So with the circle output, this idea is not working very well.