China Gracemac Paper Limited

1

Lift the printer cover door.

2

Press the blue button inside the printer compartment. The printer

roller component will pop out of its position.

3

Take-out the printer roller component and remove the old paper roll from

the printer compartment

4

Insert the new paper roll into the rear section of the printer compartment.

5

Pull the end of the roll forward so that the paper lies between the two

printer roller pivots.

6

Press the printer roller component into position on top of the two printer

roller pivots and the paper below it.

7

Feed the end of the paper through the slot in the printer cover door.

8

Close the printer cover door.

9

Tear off excess paper tape protruding from the slot. The thermal printer is

ready for printing activities.

10

Thanks For Looking!

Back