Post on 15-Sep-2018
JOHNS HOPKINS APL TECHNICAL DIGEST, VOLUME 28, NUMBER 3 (2010)254
environment through multiple mechanisms, making them ideal candidates for gaseous sensing. Analytes can bind to the receptor and influence the current flowing across the transistor channel. The response will be a change in the source–drain current for a given drain and gate voltage (see Fig. 1).
Dimethyl methylphosphonate (DMMP) is a simulant for the nerve agent sarin, while the explosive dinitro-toluene (DNT) is commonly used as a simulant for trin-itrotoluene (TNT). The electrical properties of both n-channel (electron-carrying) and p-channel (hole-carrying) transistor sensors were measured upon expo-sure to either DMMP or DNT vapors. Electron-deficient analytes will try to dope p-type organic semiconductors (OSCs) but will quench n-type OSCs. The reverse happens for electron-donating analytes. This doping or quenching competes with the dipole effect of the analyte, which will always decrease the current.
The devices were all top-contact organic transis-tors made on Si/SiO2 substrates. The film thickness was minimized for optimum response. The thinner device gave faster response times and had greater sensitivity because the conduction channel comprised most of the film. However, the reduced thickness would make the device unstable.
Small molecules and polymers were both used as OSCs. The small n-channel molecules used were bis-CF3 NTCDI (naphthalenetetracarboxylic diimide)
and C2PhF5 NTCDI. 5,5-Bis(4-n-hexylphenyl)-2,2-bithiophene (6PTTP6), 5,5-bis(4-(6-hydroxyhexyloxy)phenyl)-2,2-bithiophene (HO6OPT), -sexithiophene, and 1,4-bis(5-phenyl-2-thienyl)benzene (PTPTP) were p-channel small molecules, and poly(3,3-dialkyl-quaterthiophene) (PQT-12) was a p-type polymer. Each compound gave a clear response to DNT or DMMP (Figs. 2 and 3). Electron-conducting OSCs showed decreased current in response to both DNT and DMMP; however, the mechanisms were different. DMMP decreased the threshold voltage (Vt), whereas
Figure 1. Schematic diagram of an OFET-based sensor illustrating analyte diffusion into the film.
Chemically Responsive Organic Field-Effect Transistors
T. J. Dawidczyk*, J. Huang*, J. Sun*, K. C. See*, B. J. Jung*, H. E. Katz*, A. F. Mason†, J. Miragliotta†, and A. Becknell†
*JHU Department of Materials Science and Engineering, Baltimore, MD; and †JHU Applied Physics Laboratory, Laurel, MD
O rganic field-effect transistors (OFETs) have been studied recently in applications such as radio-frequency identification tags, display
drivers, pressure-mapping elements, and sensors. OFETs are sensitive to the
Source Drain
Dielectric
Gate
Semiconductor Analyte molecule
CHEMICALLY RESPONSIVE ORGANIC FIELD-EFFECT TRANSISTORS
JOHNS HOPKINS APL TECHNICAL DIGEST, VOLUME 28, NUMBER 3 (2010) 255
Figure 2. (a) Field-effect mobility of 6PTTP6 FETs at various film thicknesses, calculated with the linear region of the Id – Vg curves. The inner graph is also mobility but is not in log scale. (b) Sche-matic illustration of the conduction channel formation.
Figure 3. (a) DNT has little effect on threshold voltage. (b) DMMP decreases threshold voltage.
For further information on the work reported here, see the references below or contact andrew.mason@jhuapl.edu.
1Katz, H. E., and Huang, J., “Thin-Film Organic Electronic Devices,” Annu. Rev. Mat. Res. 39, 71–92 (2009). 2Huang, J., Sun, J., and Katz, H. E., “Monolayer-Dimensional 5,5-Bis(4-hexylphenyl)-2,2-bithiophene Transistors and Chemically
Responsive Heterostructures,” Adv. Mat. 20, 2567–2572 (2008). 3Huang, J., Miragliotta, J., Becknell, A., and Katz, H. E., “Hydroxy-Terminated Organic Semiconductor-Based Field-Effect Transistors
for Phosphonate Vapor Detection,” J. Am. Chem. Soc. 129, 9366–9376 (2007).
100
10–1
10–2
0.08
0.06
0.04
0.02
0.00
10–3
10–4
10–5
10–6
10–7
1.0 1.5
1 2 3
2.0 2.5 3.0 3.5 4.0
Mo
bili
ty/c
m2
V–1
s–1
Mo
bili
ty/c
m2
V–1
s–1
Thickness/monolayer
Thickness/monolayer
6PTTP6(a)s
s
Au
Au Au
Au
SiO2/Si substrate
SiO2/Si substrate
1.27 Monolayer
1.31 Monolayer
(b)
DNT decreased the mobility. Hole-transporting OSCs showed decreased current for devices without the incor-poration of receptors and increased current for devices with receptors. These different responses show the feasibility of manufacturing an array that can sense multiple analytes with each analyte having a distinct fingerprint.
(a)
0 282420161284 32 36 40Time (min)
Vt (
V)
26.0
25.5
25.0
24.5
24.0
23.5
23.0
32
30
28
26
24
22
200 10 20 30 40
Vt (
V)
Time (min)
DMMP DMMP
(b)