Post on 28-Dec-2015
Chapter 5 Microbial Nutrition and Culture
cont’dSiti Sarah Jumali (ext 2123)
Room 3/14
sarah_jumali84@hotmail.com
Microbial Growth
Requirements
The Requirements for Growth
PHYSICAL REQUIREMENTS– Temperature
– pH
– Oxygen
– Hydrostatic Pressure
– Osmotic pressure
CHEMICAL REQUIREMENTS (NUTRITIONAL FACTORS)
– Carbon
– Nitrogen, sulfur, and phosphorous
– Trace elements
– Oxygen
– Organic growth factor
1) pH
• Optimum pH: the pH at which the microorganism grows best (e.g. pH 7)
• Most bacteria grow between pH 6.5 and 7.5
• Molds and yeasts grow between pH 5 and 6
• According to their tolerance for acidity/alkalinity, bacteria are classified as:
Acidophiles (acid-loving): grow best at pH 0.1-5.4
Neutrophiles: grow best at pH 5.4 to 8.0
Alkaliphiles (base-loving): grow best at pH 7.0-11.5
Physical Factors Required for Bacterial Growth
2) Temperature• According to their growth temperature range, bacteria can be
classified as:Psychrophiles : grow best at 15-20oCPsychrotrophs : grow between 0°C and 20–30°CMesophiles : grow best at 25-40oCThermophiles : grow best at 50-60oC
Typical Growth Rates and Temperature– Minimum growth temperature: lowest temp which species can
grow – Optimum growth temperature: temp at which the species grow
best– Maximum growth temperature: highest temp at which grow is
possible
Food Preservation Temperatures
3) Oxygen• Aerobes: require oxygen to grow• Obligate aerobes: must have free oxygen for aerobic respiration (e.g. Pseudomonas)
• Anaerobes: do not require oxygen to grow• Obligate anaerobes: killed by free oxygen (e.g. Bacteroides)• Microaerophiles: grow best in presence of small amount of free
oxygen• Capnophiles: carbon-dioxide loving organisms that thrive under
conditions of low oxygen• Facultative anaerobes: carry on aerobic metabolism when oxygen is
present, but shift to anaerobic metabolism when oxygen is absent• Aerotolerant anaerobes: can survive in the presence of oxygen but do
not use it in their metabolism
• Obligate: organism must have specified environmental condition• Facultative: organism is able to adjust to and tolerate environmental
condition, but can also live in other conditions
Patterns of Oxygen Use
4) Hydrostatic Pressure
• Water in oceans and lakes exerts pressure exerted by standing water, in proportion to its depth
• Pressure doubles with every 10 meter increase in depth
• Barophiles: bacteria that live at high pressures, but die if left in laboratory at standard atmospheric pressure
5) Osmotic Pressure
• Environments that contain dissolved substances exert osmotic pressure, and pressure can exceed that exerted by dissolved substances in cells
• Hyperosmotic environments: cells lose water and undergo plasmolysis (shrinking of cell)
• Hypoosmotic environment: cells gain water and swell and burst
Plasmolysis
Halophiles• Salt-loving organisms which require moderate to large
quantities of salt (sodium chloride)
• Membrane transport systems actively transport sodium ions out of cells and concentrate potassium ions inside
• Why do halophiles require sodium?1) Cells need sodium to maintain a high intracellular
potassium concentration for enzymatic function2) Cells need sodium to maintain the integrity of their
cell walls
Responses to Salt
The Great Salt Lake in Utah
Chemical Requirement: Nutritional Factors
1. Carbon sources2. Nitrogen sources3. Sulfur and phosphorus4. Trace elements (e.g. copper, iron, zinc,
and cobalt)5. Vitamins (e.g. folic acid, vitamin B-12,
vitamin K)
Chemical Requirements
• Carbon
– Structural organic molecules, energy source
– Chemoheterotrophs use organic carbon sources
– Autotrophs use CO2
Chemical Requirements• Nitrogen– In amino acids and proteins
–Most bacteria decompose proteins
– Some bacteria use NH4+ or NO3–
– A few bacteria use N2 in nitrogen fixation
Chemical Requirements
• Sulfur– In amino acids, thiamine, and biotin
–Most bacteria decompose proteins
– Some bacteria use SO42– or H2S
• Phosphorus – In DNA, RNA, ATP, and membranes
– PO43– is a source of phosphorus
Chemical Requirements
• Trace elements– Inorganic elements (mineral) required in small
amounts– Usually as enzyme cofactors– Ex: iron, molybdenum, zinc
• Buffer– To neutralize acids and maintain proper pH– Peptones and amino acids or phosphate salts
may act as buffers
Organic Growth Factors
• Organic compounds obtained directly from the environment
• Ex: Vitamins, amino acids, purines, and pyrimidines
Preparation of Culture Media
• Culture medium: Nutrients prepared for microbial growth
• Sterile: No living microbes
• Inoculum: Introduction of microbes into medium
• Culture: Microbes growing in/on culture medium
Agar
• Complex polysaccharide
• Used as solidifying agent for culture media in Petri plates, slants, and deeps
• Generally not metabolized by microbes
• Liquefies at 100°C
• Solidifies at ~40°C
Types of Culture Media
• Natural Media: In nature, many species of microorganisms grow together in oceans, lakes, and soil and on living or dead organic matter
• Synthetic medium: A medium prepared in the laboratory from material of precise or reasonably well-defined composition
• Complex medium: contains reasonably familiar material but varies slightly in chemical composition from batch to batch (e.g. peptone, a product of enzyme digestion of proteins)
Types of Culture MediaType of Media Purpose
Chemically Defined
Growth of chemoheterotrophs and photoautotrophs: microbiological assays
Complex Growth of most chemoheterotrophic organisms
Reducing Growth of obligate anO2
Selective Suppresion of unwanted microbes; encouraging desired microbes
Differential Differentiation of colonies of desired microbes from others
Enrichment Similar to selective media but designed to increase numbers of desired microbes to detectable levels.
Culture Media
• Chemically defined media: Exact chemical composition is known
• Complex media: Extracts and digests of yeasts, meat, or plants– Nutrient broth
– Nutrient agar
Selective, Differential, and Enrichment Media
• Selective medium: encourages growth of some organisms but suppresses growth of others (e.g. antibiotics)
• Differential medium: contains a constituent that causes an observable change (e.g. MacConkey agar)
• Enrichment medium: contains special nutrients that allow growth of a particular organism that might not otherwise be present in sufficient numbers to allow it to be isolated and identified
Selective Media• Suppress unwanted microbes and encourage desired
microbes
• Ex: Sabouraud’s Dextrose Agar: used to isolate fungi, has a pH of 5.6, outgrow most of bacteria
Make it easy to distinguish colonies of different microbes.
Ex: Blood Agar: bacteria that can lysed blood cells causing a clear areas around the colonies.
Differential Media
Three species of Candida can be differentiated in mixed culture when grown on CHROMagar Candida plates
Identification of urinary tract pathogens with
differential media (CHROMagar)
Enrichment Media
• Encourages growth of desired microbe
• Assume a soil sample contains a few phenol-degrading bacteria and thousands of other bacteria
– Inoculate phenol-containing culture medium with the soil, and incubate
– Transfer 1 ml to another flask of the phenol medium, and incubate
– Transfer 1 ml to another flask of the phenol medium, and incubate
– Only phenol-metabolizing bacteria will be growing
Culturing Bacteria
• Culturing of bacteria in the laboratory presents two problems:
1. A pure culture of a single species is needed
to study an organism’s characteristics
2. A medium must be found that will support
growth of the desired organism
Obtaining Pure Cultures
• Pure culture: a culture that contains only a single species or strain of organism
• A colony is a population of cells arising from a single cell or spore or from a group of attached cells
• A colony is often called a colony-forming unit (CFU)
• The streak plate method is used to isolate pure cultures
The Streak Plate Method uses agar plates to prepare pure cultures
Figure 6.11
The Streak Plate Method
Anaerobic Culture Methods
• Reducing media– Contain chemicals (thioglycolate or oxyrase) that
combine O2
– Heated to drive off O2
Figure 6.6
Anaerobic Jar
To culture obligate anaerobes, all molecular oxygen must be removed and kept out of medium. Agar plates are incubated in sealed jars containing chemical substances that remove oxygen and generate carbon dioxide or water
Anaerobic Transfer
Figure 6.7
An Anaerobic Chamber
Capnophiles
• Microbes that require high CO2 conditions
• CO2 packet
• Candle jar
Preserved Cultures
• To avoid risk of contamination and to reduce mutation rate, stock culture organisms should be kept in a preserved culture, a culture in which organisms are maintained in a dormant state
1. Lyophilization (freeze-drying): Frozen (–54° to –72°C) and dehydrated in a vacuum
2. Deep Freezing: –50° to –95°C
3. Refrigeration
• Reference culture (type culture): a preserved culture that maintains the organisms with characteristics as originally defined
CHAPTER 6:MICROBIAL GROWTH
Growth and Cell Division
• Microbial growth is defined as the increase in the number of cells, which occurs by cell division
• Binary fission (equal cell division): A cell duplicates its components and divides into two cells
• Septum: A partition that grows between two daughter cells and they separate at this location
• Budding (unequal cell division): A small, new cell develops from surface of exisiting cell and subsequently separates from parent cell
Binary Fission
Binary Fission
Thin section of the bacterium Staphylococcus, undergoing binary fission
Budding in Yeast
Phases of Growth
• Consider a population of organisms introduced into a fresh, nutrient medium
• Such organisms display four major phases of growth in batch culture:1. The lag phase
2. The logarithmic phase
3. The stationary phase
4. The death phase
The Lag Phase• Organisms do not increase significantly in number
• They are metabolically active
• Grow in size, synthesize enzymes, and incorporate molecules from medium
• Produce large quantities of energy in the form of ATP
The Log Phase
• Organisms have adapted to a growth medium
• Growth occurs at an exponential (log) rate
• The organisms divide at their most rapid rate
• a regular, genetically determined interval (generation time)
Synchronous growth: A hypothetical situation in which the number of cells in a culture would increase in a stair-step pattern, dividing together at the same rate
Nonsynchronous growth: A natural situation in which an actual culture has cell dividing at one rate and other cells dividing at a slightly slower rate
1) Cell division decreases to a point that new cells are produced at same rate as old cell die. 2) The number of live cells stays constant.
Decline (Death) Phase1) Condition in the medium become less and less
supportive of cell division2) Cell lose their ability to divide and thus die3) Number of live cells decreases at a logarithmic
rate
Stationary Phase
Microbes growing continuously in a chemostat
Measuring Microbial Growth
Direct Methods
• Plate counts
• Filtration
• MPN
• Direct microscopic count
Indirect Methods
• Turbidity
• Metabolic activity
• Dry weight
Direct Methods1) Plate Count
• Must perform
- Serial Dilutions
- Pour plate or Spread Plate Method• often reported as colony-forming units (CFU)
Serial Dilution
Figure 6.17
Plate Counts
Figure 6.16
Plate Counts• After incubation, count colonies on plates that
have 25–250 colonies (CFUs)
2) Counting Bacteria by Membrane Filtration
3) The Most Probable Number (MPN) Method
• Method to estimate number of cells
• Multiple tube MPN test
• Count positive tubes
• Compare with a statistical table.
4) Direct Microscopic Counts
• Another way to measure bacterial growth by:
1) Petroff-Hausser counting chamber
2) Colony counting chamber
• In Petroff-Hausser counting chamber, bacterial suspension is introduced onto chamber with a calibrated pipette
• Microorganisms are counted in specific calibrated areas
• Number per unit volume is calculated using an appropriate formula
The Petroff-Hausser Counting Chamber
Direct Microscopic Count
Counting colonies using a bacterial colony counter
Bacterial colonies viewed through the magnifying glass against a colony-counting grid
Which of these plates would be the correct one to count? Why?
Countable number of colonies
(30 to 300 per plate)
Indirect Methods1) Turbidity
• Practical way of monitoring bacterial growth.
• Measure turbidity using spectrophotometer
A Spectrophotometer: This instrument can be used to measure bacterial growth by measuring the amount of light that passes through a suspension of cells
Turbidity
Turbidity
The less light transmitted, the more bacteria in sample.
2) Metabolic Activity• Assuming the amount of a certain metabolic
product, ex acids, CO2 produced = direct propotion of no of bacteria present
3) Dry Weight• For filamentous bacteria and molds• Apply filtration of amount of broth culture
on filter paper and dried in a dessicator• Weight of dried culture = direct propotion
of no of bacteria present
Biosafety Levels
• 1: No special precautions
• 2: Lab coat, gloves, eye protection
• 3: Biosafety cabinets to prevent airborne transmission
• 4: Sealed, negative pressure– Exhaust air is filtered twice
Biosafety Level 4 (BSL-4) Laboratory
Questions?