Post on 31-Dec-2015
description
1
Chapter 11
APPLIED COMPETITIVE ANALYSIS
2
Economic Efficiency and Welfare Analysis
• The area between the demand and the supply curve represents the sum of consumer and producer surplus– measures the total additional value
obtained by market participants by being able to make market transactions
• This area is maximized at the competitive market equilibrium
3
Economic Efficiency and Welfare Analysis
Quantity
Price
P *
Q *
S
D
Consumer surplus is thearea above price and belowdemand
Producer surplus is thearea below price andabove supply
4
At output Q1, total surpluswill be smaller
Economic Efficiency and Welfare Analysis
Quantity
Price
P *
Q *
S
D
Q1
At outputs between Q1 andQ*, demanders would valuean additional unit more thanit would cost suppliers toproduce
5
Economic Efficiency and Welfare Analysis
• Mathematically, we wish to maximize
consumer surplus + producer surplus =
Q Q
dQQPQUdQQPPQPQQU0 0
)()(])([])([
• In long-run equilibria along the long-run supply curve, P(Q) = AC = MC
6
Economic Efficiency and Welfare Analysis
• Maximizing total surplus with respect to Q yields
U’(Q) = P(Q) = AC = MC
– maximization occurs where the marginal value of Q to the representative consumer is equal to market price
• the market equilibrium
7
Welfare Loss Computations
• Use of consumer and producer surplus notions makes possible the explicit calculation of welfare losses caused by restrictions on voluntary transactions– in the case of linear demand and supply
curves, the calculation is simple because the areas of loss are often triangular
8
Welfare Loss Computations
• Suppose that the demand is given by
QD = 10 - P
and supply is given by
QS = P - 2
• Market equilibrium occurs where P* = 6 and Q* = 4
9
Welfare Loss Computations
• Restriction of output to Q0 = 3 would create a gap between what demanders are willing to pay (PD) and what suppliers require (PS)
PD = 10 - 3 = 7
PS = 2 + 3 = 5
10
The welfare loss from restricting outputto 3 is the area of a triangle
Welfare Loss Computations
Quantity
Price
S
D
6
4
7
5
3
The loss = (0.5)(2)(1) = 1
11
Welfare Loss Computations
• The welfare loss will be shared by producers and consumers
• In general, it will depend on the price elasticity of demand and the price elasticity of supply to determine who bears the larger portion of the loss– the side of the market with the smallest
price elasticity (in absolute value)
12
Price Controls and Shortages
• Sometimes governments may seek to control prices at below equilibrium levels– this will lead to a shortage
• We can look at the changes in producer and consumer surplus from this policy to analyze its impact on welfare
13
Price Controls and Shortages
Quantity
PriceSS
D
LS
P1
Q1
Initially, the market isin long-run equilibriumat P1, Q1
Demand increases to D’
D’
14
Price Controls and Shortages
Quantity
PriceSS
D
LS
P1
Q1
D’
Firms would begin toenter the industry
In the short run, pricerises to P2
P2
The price would endup at P3
P3
15
Price Controls and Shortages
Quantity
PriceSS
D
LS
P1
Q1
D’
P3
There will be a shortage equal toQ2 - Q1
Q2
Suppose that thegovernment imposesa price ceiling at P1
16
This gain in consumersurplus is the shadedrectangle
Price Controls and Shortages
Quantity
PriceSS
D
LS
P1
Q1
D’
P3
Q2
Some buyers will gain because they can purchase the good for a lower price
17
The shaded rectangletherefore represents apure transfer fromproducers to consumers
Price Controls and Shortages
Quantity
Price
D
P1
Q1
D’
SS
LSP3
Q2
The gain to consumers is also a loss to producers who now receive a lower price
No welfare loss there
18
This shaded trianglerepresents the value of additional consumer surplus that would have been attained without the price control
Price Controls and Shortages
Quantity
PriceSS
D
LS
P1
Q1
D’
P3
Q2
19
This shaded trianglerepresents the value of additional producer surplus that would have been attained without the price control
Price Controls and Shortages
Quantity
PriceSS
D
LS
P1
Q1
D’
P3
Q2
20
This shaded arearepresents the total value of mutually beneficial transactions that are prevented by the government
Price Controls and Shortages
Quantity
PriceSS
D
LS
P1
Q1
D’
P3
Q2
This is a measure of the pure welfare costs of this policy
21
Disequilibrium Behavior• Assuming that observed market
outcomes are generated by
Q(P1) = min [QD(P1),QS(P1)],
suppliers will be content with the outcome but demanders will not
• This could lead to a black market
22
Tax Incidence
• To discuss the effects of a per-unit tax (t), we need to make a distinction between the price paid by buyers (PD) and the price received by sellers (PS)
PD - PS = t
• In terms of small price changes, we wish to examine
dPD - dPS = dt
23
Tax Incidence
• Maintenance of equilibrium in the market requires
dQD = dQS
or
DPdPD = SPdPS
• Substituting, we get
DPdPD = SPdPS = SP(dPD - dt)
24
Tax Incidence
• We can now solve for the effect of the tax on PD:
DS
S
PP
PD
ee
e
DS
S
dt
dP
• Similarly,
DS
D
PP
PS
ee
e
DS
D
dt
dP
25
Tax Incidence• Because eD 0 and eS 0, dPD /dt 0
and dPS /dt 0
• If demand is perfectly inelastic (eD = 0), the per-unit tax is completely paid by demanders
• If demand is perfectly elastic (eD = ), the per-unit tax is completely paid by suppliers
26
Tax Incidence
• In general, the actor with the less elastic responses (in absolute value) will experience most of the price change caused by the tax
S
D
D
S
e
e
dtdP
dtdP
/
/
27
Tax Incidence
Quantity
PriceS
D
P*
Q*
PD
PS
A per-unit tax creates awedge between the pricethat buyers pay (PD) andthe price that sellers receive (PS)
t
Q**
28
Buyers incur a welfare lossequal to the shaded area
Tax Incidence
Quantity
PriceS
D
P*
Q*
PD
PS
Q**
But some of this loss goesto the government in theform of tax revenue
29
Sellers also incur a welfareloss equal to the shaded area
Tax Incidence
Quantity
PriceS
D
P*
Q*
PD
PS
Q**
But some of this loss goesto the government in theform of tax revenue
30
Therefore, this is the dead-weight loss from the tax
Tax Incidence
Quantity
PriceS
D
P*
Q*
PD
PS
Q**
31
Deadweight Loss and Elasticity
• All nonlump-sum taxes involve deadweight losses– the size of the losses will depend on the
elasticities of supply and demand
• A linear approximation to the deadweight loss accompanying a small tax, dt, is given by
DW = -0.5(dt)(dQ)
32
Deadweight Loss and Elasticity
• From the definition of elasticity, we know that
dQ = eDdPD Q0/P0
• This implies that
dQ = eD [eS /(eS - eD)] dt Q0/P0
• Substituting, we get
00
2
0
50 QPeeeeP
dtDW DSSD )]/([.
33
Deadweight Loss and Elasticity
• Deadweight losses are zero if either eD or eS are zero
– the tax does not alter the quantity of the good that is traded
• Deadweight losses are smaller in situations where eD or eS are small
34
Transactions Costs• Transactions costs can also create a
wedge between the price the buyer pays and the price the seller receives– real estate agent fees– broker fees for the sale of stocks
• If the transactions costs are on a per-unit basis, these costs will be shared by the buyer and seller– depends on the specific elasticities involved
35
Gains from International Trade
Quantity
Price
S
D
Q*
P*
In the absence ofinternational trade,the domesticequilibrium price would be P* andthe domesticequilibrium quantitywould be Q*
36
Gains from International Trade
Quantity
Price
Q*
P*
S
D
Quantity demanded willrise to Q1 and quantitysupplied will fall to Q2
Q1Q2
If the world price (PW)is less than the domesticprice, the price will fallto PW
PW
Imports = Q1 - Q2
imports
37
Consumer surplus rises
Producer surplus falls
There is an unambiguouswelfare gain
Gains from International Trade
Quantity
Price
Q*
P*
S
D
Q2Q1
PW
38
Effects of a Tariff
Quantity
Price
S
D
Q1Q2
PW
Quantity demanded fallsto Q3 and quantity suppliedrises to Q4
Q4 Q3
Suppose that the governmentcreates a tariff that raisesthe price to PR
PR
Imports are now Q3 - Q4
imports
39
Consumer surplus falls
Producer surplus rises
These two triangles represent deadweight loss
The government getstariff revenue
Effects of a Tariff
Quantity
Price
S
D
Q1Q2
PW
Q4 Q3
PR
40
Quantitative Estimates of Deadweight Losses
• Estimates of the sizes of the welfare loss triangle can be calculated
• Because PR = (1+t)PW, the proportional change in quantity demanded is
DDW
WR teeP
PP
Q
1
13
41
The areas of these twotriangles are
Quantitative Estimates of Deadweight Losses
Quantity
Price
S
D
Q1Q2
PW
Q4 Q3
PR
))((. 311 50 QQPPDW WR
12
1 50 QPetDW WD.
))((. 242 50 QQPPDW WR
22
2 50 QPetDW WS.
42
Other Trade Restrictions• A quota that limits imports to Q3 - Q4
would have effects that are similar to those for the tariff– same decline in consumer surplus– same increase in producer surplus
• One big difference is that the quota does not give the government any tariff revenue– the deadweight loss will be larger
43
Trade and Tariffs• If the market demand curve is
QD = 200P-1.2
and the market supply curve is
QS = 1.3P,
the domestic long-run equilibrium will occur where P* = 9.87 and Q* = 12.8
44
Trade and Tariffs• If the world price was PW = 9, QD would
be 14.3 and QS would be 11.7
– imports will be 2.6
• If the government placed a tariff of 0.5 on each unit sold, the world price will be PW = 9.5
– imports will fall to 1.0
45
Trade and Tariffs• The welfare effect of the tariff can be
calculated
DW1 = 0.5(0.5)(14.3 - 13.4) = 0.225
DW2 = 0.5(0.5)(12.4 - 11.7) = 0.175
• Thus, total deadweight loss from the tariff is 0.225 + 0.175 = 0.4
46
Important Points to Note:• The concepts of consumer and producer
surplus provide useful ways of analyzing the effects of economic changes on the welfare of market participants– changes in consumer surplus represent
changes in the overall utility consumers receive from consuming a particular good
– changes in long-run producer surplus represent changes in the returns product inputs receive
47
Important Points to Note:
• Price controls involve both transfers between producers and consumers and losses of transactions that could benefit both consumers and producers
48
Important Points to Note:• Tax incidence analysis concerns the
determination of which economic actor ultimately bears the burden of a tax– this incidence will fall mainly on the actors
who exhibit inelastic responses to price changes
– taxes also involve deadweight losses that constitute an excess burden in addition to the burden imposed by the actual tax revenues collected
49
Important Points to Note:• Transaction costs can sometimes be
modeled as taxes– both taxes and transaction costs may affect
the attributes of transactions depending on the basis on which the costs are incurred
50
Important Points to Note:• Trade restrictions such as tariffs or
quotas create transfers between consumers and producers and deadweight losses of economic welfare– the effects of many types of trade
restrictions can be modeled as being equivalent to a per-unit tariff