Post on 05-Nov-2015
description
GY-HM650E Live Streaming Setup Guide
VLC Media Player
1. Presetting - Installing VLC Player - Download from - http://www.videolan.org/vlc/
2. IP Address - Finding the IP address on your PC - Start > Program > Accessory > Command Prompt -TypeinipconfigtofindyourIPaddress
3. On the camera menu select [Main Menu] > [System..]
4. Change [Network] to On(SDI Off). Then Select [Settings...]
5. Select [Live Streaming Set...]
6. Set [Resolution] and [Frame & Bit Rate]
6.1 Settable Resolution during Streaming to No. of Frames
7. Set [Type] to MPEG2-TS/UDP
8. Select [Destination Address] and type in the address of your PC
9. Set [Destination Port] and set to 6504 as standard setting
10. Execute VLC media player on your PC - Open [Media] and select [Open Network System...]
11. Enter a network URL as: udp://@:xxxx - xxxx = Enter port number - Click Play - Note: Make sure you type the colon :
12. Turn [Live Straming] to ON
13. The Picture and Audio may be distorted due to network conditions - If so, lower the resolution and/or frame and bit rate
Teradek Decoder
There are four different model, as follows:
Wi-Fi/Ethernet Ethernet OnlyHD-SDI Out Cube 355 Cube 305HDMI Out Cube 455 Cube 405
The GY-HM650E demo with Teradek Cube 305 decoder.Three possible configurations:
1. Instal TeraCentral to your PC for setup. - Download from: http://www.teradek.com/pages/downloads
2. Connect your PC and Teradek decor with network (wired/wireless). You can download Cube Reference Guide at:
https://dl.dropboxusercontent.com/u/11455193/Teradek/Cube/Docs/Teradek_Cube_Reference_Guide_v2_1211.pdf
3. Turn the power of the Teradek decoder ON4. Open Browser on your PC - Note: Internet Explorer requires IE9 or higher
Pre-setting
Set-up Decoder by Tera-Central1. Open TeraCentral2. Click Configure Settings3. Login using admin as the password -Note:adminshouldbeinlowercaps
4. Click Video Setup > Decoder Settings. Set Parameters as follows: - Decoder Setting: MPEG Transport Stream - MPEG Transport Stream Settings: - Protocol: TCP or UDP - Port: 6504 - Audio Codec: AAC - Others settings should be kept as default -ClickApplywhenfinished
Note: The streaming may delay more when the Jitter Buffering is enabled. However some picture quality maybelosedifsettoDisable.Thisdependsonbandwidth.s
4. Click Network > ConfigurationWired Connection -ClickWirelessandensureWirelessModeisdisabled -IfnotclickDisableandApply -ClickWired - Setup Parameters according:
-DestinationAddress=IPaddresssetupearlier
Note: When the above settings are completed the decoder settings will become invisible from the PC. If you need to access them, do the following:
- Close the browser and TeraCentral - Change IP address setting on your PC - Open TeraCentral -ClickConfigureSettingwhendecoderisfound - When browser is opened automatically enter Username and Password to Login
Wireless Connection -ClickWirelesstab - Set mode to Infrastructure (Slave) and click Apply -Whenbelowscreenappears,clickScanForWirelessNetworksandselectyournetwork -SelectSecurityModeandenterpassword -ClickApply
5. GY-HM650 Setup - Follow points 3 - 9 under VLC Media Player -Point7shouldbesetthesameasMPEGTransportSettingsontheTeradekDecoder