Brother XR-40 Lightbulb Replacement Guides/Brother XR-40 Lightbulb... · To reassemble your device,...

Post on 18-Oct-2020

1 views 0 download

Transcript of Brother XR-40 Lightbulb Replacement Guides/Brother XR-40 Lightbulb... · To reassemble your device,...

Brother XR-40 Lightbulb ReplacementThis guide will demonstrate how to replace the lightbulb in the Brother XR-40 sewing machine.

Written By: Kevin Bickers

Brother XR-40 Lightbulb Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 7

INTRODUCTION

Replacing the lightbulb involves opening up the machine. You will need to purchase a sewingmachine bulb set, including the wire plug-in, to replace it.

TOOLS:Phillips #2 Screwdriver (1)

Utility Scissors (1)

Flathead Screwdriver (1)

PARTS:Zip Ties (1)

Brother XR-40 Lightbulb Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 7

Step 1 — Back Panel

Place the machine on a solidsurface.

Remove the 14mm Phillips #2 screwholding on the face cover.

Step 2

Remove the two 14mm Phillips #2screws and two 22mm Phillips #2screws that secure the rear casing.

Brother XR-40 Lightbulb Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 7

Step 3

Lay the machine on its side.

Remove the four 10mm Phillips #2screws that hold the bottom panel inplace.

The feet will come off with thescrews.

Step 4

Remove the bottom panel.

Brother XR-40 Lightbulb Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 7

Step 5

Place the machine upright.

Remove the rear casing.

You may have to wiggle the paneland pull at the same time.

Step 6 — Lightbulb

Using scissors, clip the two zip tiessecuring the lightbulb wire.

Brother XR-40 Lightbulb Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 7

Step 7

Place the machine on its side, withaccess to the bottom.

Gently pull out the white wireconnecting the bulb to the machine.

Step 8

Move the wire out from under theplastic hook.

Brother XR-40 Lightbulb Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 7

To reassemble your device, follow these instructions in reverse order.

This document was last generated on 2017-07-02 05:46:01 AM.

Step 9

Place the machine upright.

Using the flathead screwdriver,remove the 5mm Flathead screwholding on the lightbulb bracket.

Step 10

Remove the lightbulb assembly.

Brother XR-40 Lightbulb Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 7