Black and Decker PS1800 Case ReplacementThis guide will illustrate how to open the outer case of the Black and Decker PS1800.

Written By: Christian Aldrich

Black and Decker PS1800 Case Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 4

INTRODUCTION

This guide will illustrate how to open the outer case of the Black and Decker PS1800.

TOOLS:Phillips #00 Screwdriver (1)

Black and Decker PS1800 Case Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 4

Step 1 — Open the Outer Drill Case

Lay drill on its side, assuring that the drill-holes are facing upwards.

Use a Phillips-head screwdriver (#00) to remove all seven screws (12mm).

Step 2

After the screws are removed,separate the clam-shell (outer drillcase) in order to reveal the drill'sinner components.

Black and Decker PS1800 Case Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 4

To reassemble your device, follow these instructions in reverse order.

This document was last generated on 2018-03-23 06:25:28 AM.

Black and Decker PS1800 Case Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 4