AUTO-VISIONAUTO-VISION

ElectronicElectronic 3-D Measuring3-D Measuring

AndAnd

4 Wheel Alignment System4 Wheel Alignment System

Cabinet and ComputerCabinet and Computer The cabinet can beThe cabinet can beLocated anywhereLocated anywhereconvenient, as itconvenient, as itdoesn’t need to bedoesn’t need to beclose to the actualclose to the actualwork area . . .work area . . .as the Measuring tower as the Measuring tower has it own “PDS” has it own “PDS” (personal display system).(personal display system).

Measuring towersMeasuring towers

There is a measuring There is a measuring tower on each side oftower on each side ofthe vehicle. Eachthe vehicle. Eachmeasuring tower hasmeasuring tower hasits own handheld andits own handheld andmeasuring arm thatmeasuring arm thatcan be extended orcan be extended orretracted. retracted.

Rails Rails

A measuring rail isA measuring rail is

mounted on eachmounted on each

side of the rack forside of the rack for

the measuringthe measuring

towers to roll on.towers to roll on.

Wheel alignment Wheel alignment

Wheel alignmentWheel alignment

is very easy to do . . .is very easy to do . . .

simply press the simply press the

alignment button onalignment button on

the handheld andthe handheld and

follow the instructionsfollow the instructions

on the display screen.on the display screen.

Reports Reports

Reports can beReports can be

done before, duringdone before, during

and after the repairs …and after the repairs …

along with before andalong with before and

after wheel alignment.after wheel alignment.

Measuring toe angleMeasuring toe angle

Measuring toe isMeasuring toe is

done by measuringdone by measuring

the rear of the wheelthe rear of the wheel

then the front of thethen the front of the

wheel…wheel…

Measuring camber angleMeasuring camber angle

Measuring camberMeasuring camber

angle is done byangle is done by

measuring the bottommeasuring the bottom

of the wheel, then theof the wheel, then the

Top of the wheel.Top of the wheel.

Measuring caster angle…Measuring caster angle…

Caster angle is doneCaster angle is doneby turning the front wheelby turning the front wheelinward 10 degrees andinward 10 degrees andmeasuring the cambermeasuring the camberangle. Then turn the angle. Then turn the wheel outward 10 degreeswheel outward 10 degreesand measure the camber and measure the camber angle. The computer will doangle. The computer will dothe calculating and displaythe calculating and displaythe caster angle.the caster angle.

Under body measuring …Under body measuring …

aa

Measuring apron and A pillars…Measuring apron and A pillars…

aa

Measuring upper body panels…Measuring upper body panels…

Using measuring to position Using measuring to position dedicated fixtures…dedicated fixtures…

aa

Use fixtures along with measuring Use fixtures along with measuring arm…arm…

aa

Check out different repairs using Check out different repairs using the AUTO-VISION…the AUTO-VISION…

Full frame repairs…Full frame repairs…

Attach arms to monitor pulls…Attach arms to monitor pulls…

Again attach arm to monitor the Again attach arm to monitor the pull…pull…

Rear end repairs…Rear end repairs…

Side repair…Side repair…

THE ENDTHE END