Auto Body ToolmartChamp Frame Straightening Equipment, Inc.

2545 Mi l lenn ium Dr. E lg in , IL 60124 (800) 382-1200www.autobodytoo lmar t .com

A 4 - Corner Dolly SupportsB 4 - Extension Arms C 4 - WheelsD 28 - 3/8x1” Bolts, 16 - Nuts, 16 - Lock

Washers

Pa r ts L i s t

4701 Champ Body Do l l y

Read all assembly instructions completely before attempting to assemble unit.Improper or incomplete assembly could result in damage to Dolly or injury to user.

Body Dolly is designed to hold a maximum of 3,600lbs - DO NOT LOAD MORE WEIGHT THAN3,600lbs. Attempt to do so may result in damage to Dolly and injury to user.

WARNING

A

B

C D

Frame Straightening Equipment Inc.

Made In USA

Insert Extension Arms into Corner DollySupports. Start by by installing the ExtensionArm into the long arm of one of the CornerSupports.

Connect it to the short arm of anotherCorner Support. The Frame Brackets ontop of the Corner Brackets should befacing the same way.

Continue attaching Extension Arms in thismanner until you have the entire unitconnected. Again, check to make sure allFrame Brackes are facing the samedirection.

1. 2.

3. 4.

Install wheels onto four corner dolly supportswith supplied bolts, lock washers & nuts.Tighten securely.

Assembled Body Dolly

Auto Body ToolmartChamp Frame Straightening Equipment, Inc.

2545 Mi l lenn ium Dr. E lg in , IL 60124 (800) 382-1200www.autobodytoo lmar t .com

Screw locking bolts into threaded holes onCorner Brackets.

Adjust Dolly to desired width by slidingextension arms in or out and then securelytightening the locking bolts. For safety reasonsNO RED PAINT should be showing on theExtension Arms. If red paint is visible then slidebracket into the the Corner support arm until itis no longer showing.

5. 6.

Incorrect

Red Paint

Correct