Programming Hyundai remote key step by

step

Post by obd2express

Hyundai remote key programming successfully! With Xhorse VVDI2 key programmer.

Tools preparation:

Vvdi tools (Xhorse VVDI2)

A new vvdi remote key and the original Hyundai key

Here are the remote generation steps...

Step 1 - chip information collection via VVDI2 xhorse

Install the battery for the new wirless remote key

- take out the pcb on the remote controller

- install the battery

Generate wireless universal remote into chip signal collector via VVDI2 v1.2.2 software; VVDI2 automatically detect the chip

Press the remote control buttons and the LED will keep flashing (it means that: it’s coming into the collection status)

Signal acquisition is successful when the LED flashes rapidly

Information collection is complete. Now, ready for decoding and chip copy.

Step 2 - chip decoding and copy by vvdi2 v1.2.2

Put the chip with a battery installed into the remote control

Put the original car key into VVDI2 device for identification

Click on Start copy in VVDI2 interface

To collect information in the car and put the collector into VVDI2 (because we have been collecting data, it’s ok to put the collector into vvdi2)

Put the original key into vvdi2 key programmer again

Connect to the network, to begin decoding online

Chip decoding success!

Put the the the collector (vvdi remote key) into vvdi2

Chip copy success

Step 3 - remote control generation 

Try to start the car with the new copied key, after chip copy success

It can start the car but the remote cannot work properly

Ready to generate remote control

Use vvdi2 control generating function to generate the remote control

Put the new key into vvdi2 programmer

Finish vehicle info selection and click on Generate Remote Control

Complete

Use special equipment to program the remote

Xhorse wireless universal remote can copy a chip after regeneration as remote control, in the new equipment is the vvdi key tool (will add this function)

Done!