Post on 21-Aug-2015
Introduction :
In our project , we offer a set of commands that can serve us on the network by allowing users to know the names of the devices connected in the network and also can help the user to find the last IP connected in the network . know the present Protocol and disply the network settings and determine the path of the network.
Objectives:
1 – Determine the path of the network. 2 – know the names of the devices connected to the network.
3 – know the address of any IP in the network. 4 – Determine the path of network connection.
Tools :
Software:. command line.. name system windows 7.
Hardware :1- computers . 2- switch]3- cable UTP
(We use the network commands the examples)
1)-About arp
Displays, adds and removes arp information from network devices.
START SERTCH CMD arp
2)-About finger
Lists information about the user.
START SERTCH CMD finger
3)- About hostname.
Display the hostname of the machine the command is being run on. Additional information about the term hostname can be found on our hostname dictionary definition.
START SERTCH CMD hostname
4)-About ipconfig
display the network settings currently assigned and given by a network. This command can be utilized to verify a network connection as well as to verify your network settings.
START SERTCH CMD ipconfig
………………………………………………………………………………………………………………………………………………
5)-About pathping
pathping provides users with the ability of locating spots that have network latency and network loss.
START SERTCH CMD pathping
6)-About ping
Helps in determining TCP/IP Networks IP address as well as determine Problems with the network and assists in resolving them. See the ping definition for a full description.
START SERTCH CMD ping
7)-About nbtstat
MS-DOS utility that displays protocol statistics and current TCP/IP connections using NBT.
START SERTCH CMD nbtstat
8)-About net
The net command is used to update, fix, or view the network or network settings. Listed in the Syntax we have listed each of net commands.
START SERTCH CMD net
………………………………………………………………………………………………………………………………………………
9)-About route
Command to manually configure the routes in the routing table.
START SERTCH CMD route
10)-About tracert
The tracert command is used to visually see a network packet being sent and received and the amount of hops required for that packet to get to its destination.
START SERTCH CMD tracert
11)-About runas
Enables a user to execute a program on another computer as yourself or as another user.
START SERTCH CMD runas
Explain the the steps, and work Explain IP and Word, Help Jwaher commands.
Help Mona Introduction, objectives, PowerPoint and Word.
Bloge and in Required commands executed.
Reference:http://www.computerhope.com/issues/ch000444.htm
http://www.computerhope.com/jargon/e/extecomm.htm
http://www.radmin.com/download/
Connector Bloge